answersLogoWhite

0

What else can I help you with?

Related Questions

What is hardness for C45?

I need to know the hardness for c - 45 steel.


What is the hardness value of C45 and ST52 and SAE4140?

The typical hardness values for C45 steel is around 167-229 HB, for ST52 it is around 201-255 HB, and for SAE4140 it is around 217-249 HB. Hardness values can vary depending on the specific heat treatment and processing of the material.


If a material has a hardness of 8 can it not be scratched by a material with a hardness of 7?

Yes, a material with a hardness of 8 can scratch a material with a hardness of 7, but not the other way around. Hardness is a measure of a material's resistance to scratching, so a material with a higher hardness value can scratch a material with a lower hardness value.


Is Chemical composition of c45 is equal to en8d?

No, the chemical composition of C45 and EN8D steels are different. C45 is a European standard designation for a medium carbon steel, while EN8D is an Indian standard grade for a medium carbon steel. It is important to check the specific chemical composition of each grade to ensure suitability for the intended application.


What is Difference between mild steel and c45 material?

Mild steel, typically containing around 0.05% to 0.25% carbon, is known for its ductility, weldability, and ease of machining, making it suitable for general construction and fabrication. C45, on the other hand, is a medium carbon steel with a carbon content of approximately 0.45%, offering higher strength and hardness but lower ductility compared to mild steel. This makes C45 more suitable for applications requiring strength and wear resistance, such as gears and shafts, while mild steel is preferred for structural applications.


What material is a clutch diaphragm made of?

High grade spring steel. (Hardness with some flexability, not "springs" like a conventional "pressure plate".)


What are the factors on which hardness of a material depends?

Hardness of a material depends on the type of bonding between atoms.


How to identify a hardness of a unidentified material?

To identify the hardness of an unidentified material, you can use a hardness test such as the Mohs scale, Vickers hardness test, or Rockwell hardness test. These tests involve applying a specific amount of force to the material's surface and measuring the indentation or scratch it creates to determine its hardness.


What is hacksaw hardness testing?

Hacksaw hardness testing is a simple and rudimentary method used to estimate the hardness of a material. It involves cutting a groove into the material with a hacksaw blade and then comparing the resistance encountered while cutting to a known material hardness scale. This method is not as precise as standard hardness testing methods but can provide a rough estimate of the material's hardness.


What rockwell c hardness is grade 10.9?

The Rockwell C Hardness for a grade 10.9 fastener is 32 - 39HRC or 320 - 380Hv10


Which physical property is shown by scratching one material with another?

The physical property shown by scratching one material with another is hardness. Hardness is a measure of how resistant a material is to scratching or indentation.


Hardness of a material that scratches the knife blade?

The hardness of a material that scratches a knife blade would typically be higher than the hardness of the knife blade itself. This implies that the material is able to physically deform or remove material from the knife blade due to its greater hardness. This property is commonly assessed using the Mohs scale of mineral hardness.