your drl ( daytime running lamp) resistor is bad. It is located in front of the driver side front wheel on the frame. You can see it if you get below front of wheel, and look up on the frame. 1 bolt holding it on and 2 wires going to it.
lights on at all times
hit your dome light on/off switch 4 times...it says how to do that in your manual
on the left side at the gauge light switch is a push button , push it 4 times and it should work
see owner's manual With the ignition turned on (motor not running), pump the accelerator 3 times within 5 seconds, light should flash.
Which year van?? ed724 2000 if you want to turn them off and on by the light switch there is a dome light over right with the Tahoe key on push the light two times in less then five seconds the lights will go off till the key is cycled or the dome override is pushed two times again.
Not sure on the disconnect part, but after you start the truck, push your dome light on and off 4 times, you will hear it chime, the daytime running lights will then be out. But you gotta do it each time you start the vehicle....
when you open the drivers side door you need to remove a panel door that will allow you to access the fuse box locate the the red button to the left side and press it a couple of times until you see your tire light flash after it starts to flash hold it in for a couple of seconds and you will hear a chime 4 times and you light will be reset you need to have your key turned on but not running to be able to do this.
Running speed is about 3 m/s Light speed is about 300000000 m/s That's 10^8 times faster
600, 60(seconds)x60(minutes)=3600(seconds)/6=600
These are called daytime running lamps it is for safety reasons ====================================================== if you want them to not come on all the time, then remove the fuse labeled "DRL" (daytime running lights). It is located in the fuse panel on the right side of the dash with the passenger door open
Yes push the small button quickly 4 times located below the headlamp Knob
push your dome override switch 3 times and they will stay on. to turn them off do the same.