Regular light: flip the switch (I'm sure this is not the one you are looking for) Oven light: you find the button that says "light" if you don't have the "light" button then I don't know what you should do
For the service light, Switch ignition on, The display will flash for 2 seconds, press the button next to fuel gauge until "----" appeares in the display, Release the button and switch the ignition off, and that should reset the light for you,
Grab ahold of the light switch under the dash you should feel on the side of the light switch a spring button. Push the button in poll the light switch knob out. Then you unscrew the nut that holds the switch in. Once you get the switch out play around with it so you can see how it works. That way it's a lot easier to install it. By the way disconnect the battery or your lights will stay on.
This is the procedure for resetting the tsc light on the 99 Acura RL which should be the same. Set the parking brakes,push and hold the tcs switch (button) turn on ignition switch hold for 4 to6 seconds let go of tcs switch (button) should blink twice push button again light should go out,turn off ignition,then recheck for codes. Repeat if necessary.
There is insufficient information to answer your question since "old light switch" is open for interpretation. However, if you want to find the push button type light switch, search on the internet for "vintage electrical parts" and you should be able to find several suppliers.
with light switch off, hold the "off" button on the fan part of the control & then turn light switch on while still holding the button.
Unplug switch. On top of switch you will find a small spring loaded metal button. While pushing down on button, pull out on head light switch knob. Knob should now come out of switch. [ headlights will come on, you might want to disconnect battery] Now remove round nut on front of dash. After replacing switch, just push headlight knob into new switch [no need to push metal button].
May be the switch There should be a button on the side of the switch (behind the dashboard) Push this button and knob/rod assembly should come out allowing you to remove bezel and switch Also replace connector when replacing switch--they have a tendency to overheat and not make good contact
Turn the ignition switch to off. Now push and hold the odometer reset button in, now turn the ignition switch to the on position, wait from 10-15 second and the light should go off. Release the reset button an turn the ignition switch off.
It should be at the top of your brake pedal it will look like a little push button switch the releases when the pedal is depressed
If anything, there should be a switch or reset button on the back or bottom on the light (if its a portable lamp). If there is none, contact the company or consult an instruction manual.
To turn on the bike light, locate the power button on the light itself or the switch on the handlebar mount. Press or toggle the button to activate the light.