0
What else can I help you with?
If your car is in a hydroplane you should?
Keep your foot off the brake and gas pedals and coast until you regain traction.
How many foot pedals does a automatic car have?
Well, honey, an automatic car typically has two foot pedals: one for the gas and one for the brake. Unless you're counting the one your husband keeps confusing with the gas, which is the one on the far left called the clutch. But in a standard automatic car, it's just two pedals to get you from point A to point B without breaking a sweat.
When the vehicle was at a complete stop the engine began to reeve and lunged forward. When the brake was pressed down further the vehicle continued to lunge forward.?
I have had this happen to me and my foot was on both the gas and brake pedals at the same time.
How do you brake down the number 32?
Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.Take your foot off the gas and move it to the pedal on its side - the brake pedal.
Can you pass the driving test using both legs?
No, you must use only one. (Unless you are driving a manual shift vehicle, and use your other foot for the clutch. ) But still, you are supposed to use just one foot for both gas and brake. It would be both counterproductive and mechanically unwise to use one foot on the gas and one on the brake. When you need to brake, if you still have a foot on the gas, you won't be slowing much-- any slight speed advantage in depressing the brake is greatly outweighed by the likelihood of depressing both pedals at once.
What factors affect the speed of a car?
Whether or not the brake and/or gas pedals are pressed, how far they are pressed, & for how long.
What are the functions of the 3 pedals in a manual transmission car?
The three pedals in a manual transmission car are the clutch, brake, and gas pedals. The clutch pedal is used to disengage the engine from the transmission to change gears. The brake pedal is used to slow down or stop the car. The gas pedal is used to accelerate the car by increasing the engine's speed.
How is it possible to confuse the gas and brake pedals?
In some instances the brake pedal and accelerator are set too close together. This was the case in the 1980s with the Audi 4000 & 5000. This caused people to push both pedals at the same time and cause accidents. But in most cases it is caused by drive error. The driver believes he is pushing the brake pedal when in fact he is pushing the accelerator. How is this possible? Do you not know by now that, for the most part, people today are not that mechanically smart. They may have lots of so-called book learning but common sense eludes them. They think they are pushing the brake pedal and will not accept the fact that they are not. Commons sense tells you that if the car is accelerating and not stopping you are pushing the wrong pedal, but alas they are not smart enough to see that. You cannot fix stupid.
How many foot pedals does an automatic car have?
Usually two, gas and brake. There may also be an emergency brake pedal (usually far away from the other pedals, right up against the side wall) and in older cars there's often ... well, "pedal" is generous, but there may be a step switch for turning on and off the high beams on the headlights. If so, the switch will usually be in the "corner" of the driver's foot area as far from the center of the car as it's possible to get.
Does a 2001 Chevy cavalier have a brake light switch and where is it located?
It does have a switch and it is located under the dash on the driver's side (between the brake and gas pedals). There should be a cover over the componant that easily comes off. It does have a switch and it is located under the dash on the driver's side (between the brake and gas pedals). There should be a cover over the componant that easily comes off.
What is the hold button for on Mitsubishi montero?
The hold button as explained in the manual is a 'hill hold' button if you are starting and stopping (off road) on a hill. It will presumably prevent the vehicle from drifting backward as your foot moves between the gas and brake pedals.
When the driver moves his foot from the gas pedal to a positi?
Covering the brake
