five possible uses :
* Calibrate an oscillator
* Compare two frequency generators
* Phase shift determination b/w V and I in any CR circuit
* study Beats phenomenon
* study Lisajjous figures
30 microfarads
Yes, a 5-15P can be connected to a 5-20R (but not the other way around). If it is an L5-20R, then no. Be sure to use the correct gauge wiring when adding a 5-20R as it is for up to 20 amps; you cannot use the same gauge that is normally used for 5-15R (15 amps).
14-2 is rated for 15 Amp circuit. You can design a 15 Amp circuit to carry about 1440 Watts. The average outlet uses about 180 Watts and your pull chain is 60 Watts. You should have plenty of room on this circuit.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
A 3-ton air conditioner with a 15 SEER (Seasonal Energy Efficiency Ratio) rating typically uses around 3,500 to 4,000 watts when running. To estimate power consumption, you can divide the BTU output (approximately 36,000 BTUs for a 3-ton unit) by the SEER rating, which gives you about 2,400 watts. However, considering inefficiencies and startup power, the actual usage is higher. Therefore, expect around 3,000 to 4,000 watts during operation.
AWG 10.
15
RAY RAY is 15 in 2012.
yes he just turned 15
she is 15
15
ray ray is 14 and his girlfriend is 15
Roc Royal is 14Ray Ray is 15 like prodRoc is the only 14 years old while Princeton Prodigy and Ray Ray are 15
Prodigy 16, Ray Ray 15, Princeton 15, and Roc Royal 15
Prodigy is 15 Ray Ray is 15 Roc Royal is 14 and Princeton is 15
princeton-15 ray ray-16 prodigy-16 roc-15
15
15