In most cases that will work just fine. But it might not; you just have to try. Going smaller is safe.
I would say no as it could blow and if majorly can damage the plug and can be expensive to repair
Yes, you can put a 60 amp fuse in a 100 amp disconnect, but it may not be ideal. The disconnect can handle up to 100 amps, but using a lower-rated fuse like 60 amps will limit the maximum current that can pass through the circuit. This setup may protect downstream devices, but it could also lead to nuisance tripping if the load exceeds 60 amps. Always ensure that the fuse rating aligns with the load requirements and local electrical codes.
Another 750 mA fuse. 750 mA is equal to .75 amps. The max I would put in is a 1 amp fuse and I would want to replace it soon with the proper one.
Yes, you can use a 20 amp fuse with 14-gauge wire, as 14-gauge wire is typically rated for up to 15 amps for power transmission in most residential applications. However, using a 20 amp fuse may not provide adequate protection against overcurrent conditions, potentially risking overheating and fire hazards. It's essential to follow the National Electrical Code (NEC) and consult local regulations to ensure safety and compliance. In general, it's better to match the fuse rating with the wire gauge for proper protection.
You should not load a 125 amp panel any more than 100 amps.
In the UK, you cannot put a 5 amp fuse in a 3 amp plug. The general rule of thumb is that you should use like for like.
I would say no as it could blow and if majorly can damage the plug and can be expensive to repair
The short answer is yes. As long as the connector's ratings are equal or greater than the appliance. {i.e. 250volt, 10amp v.s. 240volt, 10amp}.
Install the fuse that is required for the circuit.
20 amp
Yes. You put a bigger fuse and you will melt the wire and cause a fire hazard.
Not a good thing to do! If you are blowing 10 amp fuses, you have a problem with that circuit. Putting a 30 amp fuse in its place can do more damage.
A 13 amp fuse that is in-line with a computer plug would stop the computer from ever using more than 13 amps, and would blow the fuse to do so. Before doing that, make certain that the wire and all other devices up to and including the computer power supply can adequately deal with 13 amps.
Yes it has in the plug that you put into the mains.
Your telling us ask us anything you just put stupid questions
Your telling us ask us anything you just put stupid questions
If it is the right size, then yes. But why would you want to do that? if the slot is meant for a 20 amp fuse then most likely there will be more than 10 amps running through it and it will blow almost imediately