answersLogoWhite

0

how to work a project on speed breaker energy

User Avatar

Wiki User

11y ago

What else can I help you with?

Continue Learning about Electrical Engineering

What is the speed of electricity in copper?

13,600 miles per second :-) True dat


What converter is common to power plants?

The common converter used in power plants is the synchronous generator, which converts mechanical energy into electrical energy. Synchronous generators operate at a constant speed and are widely utilized in large power generation facilities due to their efficiency and ability to maintain system stability. Additionally, in renewable energy applications, power plants may also use power electronic converters, such as inverters, to convert DC electricity from sources like solar panels into AC electricity for the grid.


How do you flash the field of a generator?

start generator, plug in variable speed drill, set drill to forward, squeeze trigger, quickly spin drill in reverse by hand. be sure generator main breaker is on.


What is fault mva rating of circuit breaker?

Pre 1970 (72?) breakers were specified with a MVA assymmetrical interrupting rating. Breakers are now spec'd with a symmetrical rating, which is provided in amps or kA. There is an ANSI standard that provides conversion from assymetrical to symmetrical and vice versa. Converting from Asym. to symmetrical involves analyzing the open close interval, time between successive openings, breaker operating speed, breaker operating voltage, and whether the breaker is connected to a generator bus or not (usually has an unusually high X/R ratio which results in more DC offset). So...it is the interrupting rating, or how much (short circuit) power the breaker can interrupt. The faster the breaker operates, the higher the voltage, the closer it is to a generator, and the more times it is expected to open results in a lower interrupting amperage capability. If it is used beyond this rating, it is likely to internally fault when attempting to open.


How much minimum torque is required by a turbine to generate Electricity?

initial torque to overcome the friction in generator and then to keep constant speed of stator within the generator. Minimum 50NM

Related Questions

Does electricity generation in dynamo depend on speed of spindle?

Yes


How do you use speed breaker on need for speed carbon?

you press R3


What happened to the speed of computers as they moved from first generation to fifth generation?

The speed of computers increased from one generation to the next generation, and to the next generation, and so on.


Is electricity as fast as light?

No, electricity does not travel at the speed of light. The speed at which electricity travels depends on the medium it is passing through. In most cases, electricity travels at a fraction of the speed of light.


What is an advantage for electricity?

it is very flexible and can be transported to very long distances at the speed of light which is not possible in other form of energy. Electricity is neither available nor required in Electric form. consumption and generation of electricty should be done at a time


What is faster sound or electricity?

Electricity is faster than sound. The speed of electricity through a conductor is close to the speed of light, which is much faster than the speed of sound through air.


What is the speed of electricity in copper?

The speed of electricity in copper is typically around 95 of the speed of light, which is approximately 186,282 miles per second.


What is the minimum wind speed to generate electricity?

A typical wind turbine starts generating electricity at wind speeds around 6-9 miles per hour (mph). The most efficient electricity generation occurs at wind speeds around 25-30 mph. Below 6 mph, wind turbines may not produce any electricity.


What is the minimum speed of the 6v motor to produce electricity?

The minimum speed of 6v motor to produce electricity is 15 Mph.


Why could the increase use of wind turbines cause fluctuation's in the electricity supply?

The fluctuation in electricity supply from an increase in wind turbines is due to the variability of wind energy. Wind speed is not constant, so the electricity generation from wind turbines can vary throughout the day. This inconsistency can lead to fluctuations in the overall electricity supply when wind energy makes up a significant portion of the grid.


Drawbacks of speed breaker generating electricity?

Next time on the roads, don't scoff at the speed-breakers. They could actually light up small villages off the highway. An amateur innovator in Guwahati has developed a simple contraption that can generate power when a vehicle passes over a speed breaker. Kanak Gogoi, a small time businessman, has developed a mechanism to generate power by converting the potential energy generated by a vehicle going up on a speed breaker into kinetic energy. The innovation has caught the eye of the Indian Institute of Technology (iit), Guwahati, which will fund a pilot project to generate electricity from speed-breakers. The idea is basic physics. Gogoi has welded five-metre-long metal plates into the speed-breaker instead of the conventional bitumen-and-stone-chip rumble strip. The plates are movable and inclined with the help of a spring-loaded hydraulic system. The fulcrum-attached plates are pushed down when a vehicle moves over them and bounce back to original position as it passes. "When the vehicle moves over the inclined plates, it gains height resulting in increase in potential energy, which is wasted in a conventional rumble strip," Gogoi says. "When the plates come down, they crank a lever fitted to a ratchet-wheel type mechanism. This in turn rotates a geared shaft loaded with recoil springs. The output of this shaft is coupled to a dynamo to convert kinetic energy into electricity," he explains. iit Guwahati has evaluated the machine and recommended it to the Assam ministry of power for large scale funding. A K Das, a professor at iit's design department says it is a 'very viable proposition' to harness thousands of mega watts of electricity untapped across the country every day. "A vehicle weighing 1,000 kg going up a height of 10 cm on such a rumble strip produces approximately 0.98 kilowatt power. So one such speed-breaker on a busy highway, where about 100 vehicles pass every minute, about one kilo watt of electricity can be produced every single minute. The figure will be huge at the end of the day," he said. The Assam power ministry is expected to back the iit pilot project. Das says a storage module like an inverter will have to be fitted to each such rumble strip to store this electricity. The cost of electricity generation and storage per mega watt from speed-breakers will be nearly Rs 1 crore as opposed to about Rs 8 crore in thermal or hydro power stations


What does the g represent in 3g?

the g stands for generation its the 3rd generation of internet speed development