let the mosfet be biased in saturation regior.
thus drain current in independent of drain to sourse voltage,
the VI chara. is a curve, when this is extended till X axis at pt. Vds=-Va
this is similar to effect in transistor
the o/p resistance is slope of V-I chara.. it should ideally be infinite, but has some finite value due to "CHANNEL LENGTH MODULATION"
It depends on the voltage applied it can be zero to a very finite value. by knowing current and using Boltzmann constant the impedance can be found. Answer: Typically: 700 Ohms when Forward Biased and >2000 Ohms when Reverse Biased.
The effect the multimeter might have on the circuit when inserted to measure the current is to increase the circuit resistance and decrease the available voltage to the circuit. This is because the multimeter in amps or milliamps mode does have a small resistance which is not zero, so by Ohm's law, there is a voltage drop across the multimeter; small, but not zero. Usually this effect is small. One way to compensate is to start by measuring voltage, and then inserting a separate ammeter and adjusting the power supply to match the original voltage. Of course, the voltmeter must be downstream of the ammeter.
No because it has finite power therefore infinite energy => not an energy signal
A time limited signal is one that is nonzero only for a finite length time interval.
The unit step signal is a Power signal. Since when we find the power it comes to 1/2 (i.e finite value). And when we find its energy, we got INFINITY. If a signal has energy as infinity and power as a finite non-zero value, then it is a power signal, not an energy signal.
what do you mean by looping?
The source is finite. Any real world power source is finite. You will see the same thing with a battery, for example (the battery has internal resistance). If you have no voltage at that recepticle, the resistance should approach infinite due to an open circuit (open breaker, fuse, broken conductor, etc.).
An ammeter has a finite resistance which is inserted in series with the rest of the circuit, increasing the total resistance and decreasing the current. A good ammeter has a very low resistance, so it shouldn't affect the circuit noticeably.
It is a finite number.It is a finite number.It is a finite number.It is a finite number.
Yes
prove that every subset of a finite set is a finite set?
There are a finite number of apartments. Finite numbers may be large or small. There are a finite number of states. The number of molds in my fridge is not exactly finite.
-- rounding errors in computation -- non-ideal components, such as diodes with finite reverse resistance, inductors with resistance, power supplies with non-zero internal impedance, wire with inductance, etc.
It is finite.
Coal is a finite resource on Earth.The finite resources will eventually run out.
finite is an object , and they are also singular in nature
I would guess that is because it has a finite number of different states. (It is also known as a finite-state machine.)