we know that ratio of holding current to latching current in scr is 0.4.
how to calculate the value of hfc for a given hfe
To calculate the admittance if you are given the impedance, you take the inverse of the impedance ( that is 1/z).
If you are asking whether power-factor improvement has any effect on a wattmeter reading, then the answer is no, it doesn't. Improving the power factor of a load has absolutely no effect on the power of the load, but it can act to reduce the value of the load current.
rated current is the current at any given conditions......but full load current is the maximum current that the system design can hav.....it w'll b larger than that f the rated current. rated current is the current at any given conditions......but full load current is the maximum current that the system design can hav.....it w'll b larger than that f the rated current.
An inductor is a device that resists a change in current. The equation is di/dt = v/L. This means that inductors are current sources, and given a sufficiently large inductor, in comparision to the circuit, it is a constant current source.
You can't do that calculation given only that data. It depends more on the design of the LED than its drive levels.
To calculate the voltage, you need to know the current (amperage) as well. The formula to calculate power (watts) given voltage (volts) and current (amps) is: Power (P) = Voltage (V) x Current (I). Without knowing the current, it is not possible to directly convert watts to volts.
by getting the difference between current assets and stock and then dividing the difference by current liabilities.
To calculate current flow, use the formula: Current (I) = Power (P) / Voltage (V). Substituting the given values, the current flowing through the electric iron would be I = 1200W / 240V = 5A.
Rated voltage is the voltage at primary side. Rated current can be found from the equation, Rated Current= Output KVA / Output rated voltage
P = E * I Power (watts) equals voltage (E) times current (I)
P = I^2 R = IV = v^2 / R , Where P is power, I is current, R is resistance, and V is voltage. Given voltage and current, power = current * voltage, or P = IV.
Given the following information, calculate the inventory for Big Show Videos: Quick ratio = 1.2; Current assets = $12,000; Current ratio = 2.5 a) $4,800 b) $6,240 c) $7,200 d) $5,660 You can also get answer on onlinesolutionproviders com thanks
Divide the watts by the voltage to get current (amps). 60W / 250V = about 1/4 Amp.
how to calculate the value of hfc for a given hfe
In that case, it would be good to know WHAT is given. If NOTHING is given, you really can't calculate.
i was given an assignment , I'm not current i was given an assignment , I'm not current i was given an assignment , I'm not current