rated current is the current at any given conditions......but full load current is the maximum current that the system design can hav.....it w'll b larger than that f the rated current. rated current is the current at any given conditions......but full load current is the maximum current that the system design can hav.....it w'll b larger than that f the rated current.
The ratings state the limits on voltage and current for operating the transformer at full load. The rated voltage times the rated current gives the rated VA of the transformer. Transormers are not usually rated directly for power because this depends on the power factor of the load applied.
While starting a motor from standstill to its rated speed, the motor has to overcome the inertia and generate enough torque to over come it. In the process the motor takes higher current during the starting. Once started and set in motion the current reduces ti its normal value. Full load current is lower than the starting current normally.
This is the current flowing in the primary circuit when full-load current flows in the secondary circuit.
Full load starting current is typically in the region of 5or 6 times the full load motor current;.
It is the rated maximum current that can be taken from the transformer. This is equal to the VA rating divided by the output voltage. So a 6 kVA 240 v transformer would have a maximum current rating of 6000/240 or 25 amps.
"Rated current" is the current the device (motor or transformer?) is designed to handle at full load. "Tripping current" is the current where a protective device (fuse, breaker) will open to protect the device from overload/overheating. "Tripped current", may be the current the tripping device measured prior to making the decision to trip, if you are reading this from a digital protective device like a relay or OCR.
Consumer surplus is the difference between the maximum amount a person is willing to pay for a good and its current market price. Producer surplus is the difference between the current market price and the full cost of production for the firm.
What is the difference between Modified accrual and Full accrual method?"
The ratings state the limits on voltage and current for operating the transformer at full load. The rated voltage times the rated current gives the rated VA of the transformer. Transormers are not usually rated directly for power because this depends on the power factor of the load applied.
Uh, is there a difference?
Starting current is the current for starting the motor initially. So it requires much more current than it of normal condition. Full load current is the current for maximum current to keep the motor.
Full form of GPRS
what is difference between MD and dm degree
Since (in North America, at least), the horsepower of a motor describes its rated output power, you need to know its efficiency in order to determine its input power, then its rated voltage, to determine its full-load current.
fill is a verb (fill in the blanks) full is a adjective (You are full of ideas)
Motors doesn't use its maximum rated current because the circuit breaker will trip immediately or is tripped off easily if there are fluctuations in our voltage regulations.
It exists when the AD exceeds the productive capacity of an economy (LRAS). The amount is the difference between the current level of income and the income at full capacity, if the economy is producing over full employment.