You don't. Motors have vents to dissipate heat. Although you can see the windings through these vents, don't cover them or the motor will overheat and burn up.
Windings
The motor connection diagram should be on the inside cover plate of the motor's junction box cover. To reverse the motor direction just reverse the starting winding leads while leaving the running windings just as they are. The starting winding numbers are sometimes numbered 1 and 4.
For a D.C motor it is the field windings which must always be in series with the armature windings.
Shunt Motor
A motor that relies solely upon the impedance of the windings to prevent overheating.
Windings
The windings of the motor will be gonebecause of high current diectly goes to the windings of motor.
No, it is not necessary to have three-phase rotor windings for a transmitter and motor in a selsyn motor. Selsyn motors typically use single-phase rotor windings to transfer information or control signals between devices. The synchronization between the transmitter and motor is achieved through the interaction of the stator and rotor windings.
A synchronous motor comprises of a stator windings and a rotor with a squirrel cage and inside that is windings(coils). At starting, this motor is an induction motor running with slip. After the rotor has reached a certain speed, a DC current is applied to the windings inside the squirrel cage. A fixed field is induced in these windings. This field locks in with the synchronous rotating magnetic flux of the stator windings. The rotating stator windings then pull the rotor along. The amount of excitation current can be used to control the power factor of the motor, making this a popular type of motor for high power use with a constant mechanical load.
The bimetallic overload protector is mounted in series with the motor windings. Should the current in the motor windings increase to a dangerous value, the heat developed by the passage of the current through the protector will cause it to open. This breaks the circuit to the motor windings and stops the motor before any damage can occur.
The number of windings in a ceiling fan motor generally depends on the motor's design and size. Typically, these motors have multiple windings, which are coils of wire wrapped around the motor's core. The windings create electromagnetic fields that interact with the motor's magnetic components to generate rotary motion.
The motor connection diagram should be on the inside cover plate of the motor's junction box cover. To reverse the motor direction just reverse the starting winding leads while leaving the running windings just as they are. The starting winding numbers are sometimes numbered 1 and 4.
The bimetallic overload protector is mounted in series with the motor windings. Should the current in the motor windings increase to a dangerous value, the heat developed by the passage of the current through the protector will cause it to open. This breaks the circuit to the motor windings and stops the motor before any damage can occur.
For a D.C motor it is the field windings which must always be in series with the armature windings.
To determine whether there are any electrical shorts among windings, or from windings to case ground.
Shunt Motor
Reverse the polarity of armature windings of the motor.