0
What else can I help you with?
How do you rewire?
The usual procedure is to remove the old wire and replace it with new wire.
Why use 3 wire 240 volt receptacle instead of a 4 wire 240 volt receptacle?
Use the 4 wire if possible. You would only use a 3 wire for an old appliance.You shouldn't if possible. The 3 wire has no neutral wire as the 4 wire does. Som applications require the use of a 3 wire and some don't.
What are the white green and black wires on an old fridge?
In an old refrigerator, the white wire typically serves as the neutral wire, the green wire is used for grounding to ensure safety, and the black wire is usually the hot wire that carries the electrical current. It's important to follow the correct wiring protocol when dealing with electrical appliances to prevent hazards. Always refer to the manufacturer's manual or consult a professional electrician for specific wiring diagrams and safety instructions.
Who invented the wire?
It depends if you mean the telegraph or wiring. The telegraph was invented by Samuel Finley Breese Morse around 1832. If you mean just wire, nobody really knows who invented it. Wire is probably over 4000 years old.
Why do outlets have two prongs?
Actually they have 3. A round ground, wide neutral, and narrow hot. If it only has 2 it is an old outlet with no ground wire. If that is the case in your home, I highly suggest you connect a jumper wire from the ground screw to the white neutral wire on the silver screw to provide some protection. Do this at every outlet in the home. Replace all the outlets in your home with new ones if they are so old they do not have a ground connection.
How do you rewire?
The usual procedure is to remove the old wire and replace it with new wire.
How do you change spark plugs wires on a 2000 range rover?
You have to put the new wires where the old wires were. Take off one wire at a time ,when you remove the wire you should measure the old wire to a new wire and you should repeat this with each wire.(DONOT TAKE OFF ALL OF THE AT ONE TIME)
How do you rewire speakers in a 1990 GMC suburban?
first you must remove the plastic casing from the rear speakers and remove the dashboard. then disconnect the old speaker wire from the old speakers and tie the new wire to the old wire. at the radio, pull the speaker wires one by one until the new wire reaches you. then splice the new speaker wire to both the radio and the speakers and replace the dash and covers
How should old 3 wire stove be wired in panel bare wire to neutral or ground or both?
The bare wire from the old 3-wire stove should be connected to the grounding terminal in the panel. The neutral and ground should not be bonded together at the stove. If the stove requires a 4-wire connection, it's best to run a new 4-wire circuit to meet current electrical codes for safety.
Updating old 3-way switches that have old wire rope?
Just change the switch, The type of wire has no bearing. The insulation will be brittle. If needed wrap the ends in the box with electrical tape. Only other solution is replacing the wire which means ripping out the wall and ceiling to get to the wire.
What are the ratings and certificates for The Wire - 2002 Old Cases 1-4?
The Wire - 2002 Old Cases 1-4 is rated/received certificates of: Netherlands:16
Can damp old wires in a wall catch fire?
it depends on how old the wire is and how wet it is but it can be possible
How old was mel Gibson when he acted bird on a wire?
31
How can I add a ground wire to an old house?
To add a ground wire to an old house, you can hire a licensed electrician to install a new ground wire that connects to the electrical panel and grounding rods. This will help protect your home from electrical hazards and ensure safety.
Why use 3 wire 240 volt receptacle instead of a 4 wire 240 volt receptacle?
Use the 4 wire if possible. You would only use a 3 wire for an old appliance.You shouldn't if possible. The 3 wire has no neutral wire as the 4 wire does. Som applications require the use of a 3 wire and some don't.
How do you install car stereo?
pull out the old one put in the new one, wire to wire color coated. power it izup
What happens if you incorrectly connect old black wire to new white wire?
If the wires are incorrectly connected the idea is that it will blow the fuse.
