My teacher gave me that wack question as homework today :(
A circuit breaker does not have a wire fuse in it.
printed circuit board
Yes, you install a GFCI on a 2 wire circuit.
the answer is the mother board of the computer
A circuit board connector is used to mechanically support and connect electronically the various components of a circuit board. It does this using conductive pathways and signal traces.
It is called a trace.
when high voltage creats in circuit board then fuse difused him self and save the circuit board. for ex>>>>wire resistance....
an interrupt
interrupt
To wire a circuit for a ceiling fan installation, first turn off the power to the circuit at the breaker box. Then, connect the fan's black wire to the black wire in the ceiling, the white wire to the white wire, and the green or bare wire to the ground wire. Secure the connections with wire nuts and install the fan according to the manufacturer's instructions. Finally, turn the power back on and test the fan to ensure it is working properly.
to assemble a circuit you just need to connect one end of a wire to the battery and the other to the light bulb ( could be another electrical device) now take an other wire and connect on end of it to the other side of the battery and the other to the other side of the light bulb( or an other electrical device. if your circuit is including a switch this is how you do it: ( you will need three wires for this circuit if you have one electrical device) connect one end of the wire to the battery and the other to the switch.Grab another wire and attach one end of it on the other side of the switch and the other to the electrical device (light bulb). Grab another wire and attach one end of it to the other side of battery and the other to the other side of your electrical device. And there you have it how to assemble a circuit
The common wire in a typical electrical circuit is the neutral wire.
The main circuit board of the computer is the motherboard.
That would be a 40 amp 220v circuit. Circuit breaker is 40 amps and wire is 8 awg. Should use solid copper wire. Follow oven installation instructions.
A printed circuit board is just a thin piece of board that allows electronics component to be connected to each other. It uses conductive pathway to track, or to signal trace etched from copper sheets laminated on to a non-conductive substrate. The circuit wire are clearly built on the board. The PCB can also referred to as printed wiring board or etched wiring board. As clearly the answer to this question is: A printed circuit is just a printed wiring board,is just a piece of board, it is pure; there are no electronic component are placed on the board yet. A mother board is a board which all electronics component are built on the printed circuit board already, as a main board of a microcomputer.
rigid-flex circuit board
is the main printed circuit board (PCB)