because in laboratory almost we are using only three phase equipents,so we require more pewer in laboratory, thats why we are generating high voltage in laboratory.
mader chod vale
A high pot test is a test of a wiring system for high potential (voltages). It's also called a megger test. This test verifies the integrity of a wire's insulation, and ensures that high voltages cannot escape through cracks in the insulation smaller than the human eye can see.
The standard voltage for transmission is about 115 to 1,200 kV (long-distance transmission). The extreme high voltages are measured more than 2,000 kV and it is exists between conductor and ground.Answer for UKThe standard transmission voltages in the UK are 400 kV and 275 kV. Primary distribution voltages are 132 kV and 33 kV, and secondary distribution voltages are 11 kV and 400 V. These are all line voltages -i.e. voltages measured between line conductors.
when transmission we usually use high voltages becoz at higher voltages current is less(p=vi,voltage is inversly proportional to current at constant power) so that we can minimize copper losses i2R losses.
Alternating current is not necessairly low voltage, on the controrary AC is more oftenly used for when high voltage is needed. Most power distribution systems (extremely high voltages) use AC because AC is easier to transform to high voltages (using the aptly named transformer). High voltage is needed for power distribution to decreases losses due to transmission.
because you will get shockedHigh voltages are not used in residential settings primarily because of electro-magnetic interference. Although it would be much more efficient you would never be able to watch tv,listen to a radio...etc.AnswerHigh voltages are only necessary for the transmission and distribution of electricity; the reasons for this simply don't apply at the point of use. The hazards involved with high voltage make it completely unsuitable for use in the home.
Electric current from a generating plant is a alternating current transmitted at high voltages, but usually used at low voltages.
we generate high voltage (DC,AC or Impuse) purposely for insulation testing of various components in power systems. Physics labs need high voltage to accelerate subatomic particles.
Power lines run at high voltages to overcome line loss.
I need this for my project and I cant get any info
Government Laboratory High School Rajshahi was created in 1969.
Urban Academy Laboratory High School was created in 1986.
High Energy Materials Research Laboratory was created in 1960.
Government Laboratory High School was created on 1961-09-03.
A good laboratory to test out high voltage experiment should be a government owned laboratory, or one that is government approved.
In the marine system, what is considered high voltages are 3.3 kV, 6.6 kV, and 11 kV. The low voltages, on the other hand, are below 1 kV.
It's dangerous at high voltages.
Central Mindanao University Laboratory High School was created in 1965.