When electricity takes a new path that is shorter than normal or in the electrical trade it is know as, current taking the path of least resistance, it is known as a short circuit.
Electricity is lazy by nature & it will always find the path of least resistance. Many times this path is also the shortest distance path from a positive charge to a negative charge, but not necessarily, it must also be the least resistive path. Typically, a short circuit is a case where a piece of metal connects two points of different voltage potential together, thus bypassing the rest of the circuit and creating a "short" in the circuit.
A 300 grams of water takes about 90 seconds to boil in a 2 kW kettle, so that is 2000 watts x 90 seconds which is 180,000 Joules of energy. But to convert that water completely into steam requires an extra 300x550x4.2 Joules, which is nearly 700,000 Joules. So converting it to steam takes 4-5 times as much energy as boiling it. That is why it takes a while for a kettle to boil dry.
when water fiows from water resource then potential energy converts into kinetic energy. due to this water rotates to the turbines and conversion of kinetic energy into mechanical takes place . the shaft of turbine is connected to generator and in turbine due to rotation magnetic flux takesplace and electricity is produced.
A: THYRISTOR can be used to clamp damaging energy as opposed to a fuse that must blow open and invariably takes time to blow. A thyristor is much faster and controllable actually if the problem disappear it can be made to open up again and restore power for normal operation.
The generation of Arc in high voltage lines takes place whenever the voltage is enough to allow current to jump across conductors by breakdown of insulator. Arcing mainly occurs when the insulation properties of insulators are permanently damaged resulting in complete system failure
Short Circuit
The path electricity takes is called a circuit.
Overhydration occurs when the body takes in more water than it excretes and its normal sodium level is diluted.
The path electricity takes is called a circuit.
Sure, it is commonly done, in hydroelectric plants. The energy from the falling water is converted into electricity. Please note that it takes energy to get the water up again. This occurs in nature due to the Sun's energy.Sure, it is commonly done, in hydroelectric plants. The energy from the falling water is converted into electricity. Please note that it takes energy to get the water up again. This occurs in nature due to the Sun's energy.Sure, it is commonly done, in hydroelectric plants. The energy from the falling water is converted into electricity. Please note that it takes energy to get the water up again. This occurs in nature due to the Sun's energy.Sure, it is commonly done, in hydroelectric plants. The energy from the falling water is converted into electricity. Please note that it takes energy to get the water up again. This occurs in nature due to the Sun's energy.
depens how smart this person is. Sometimes we go to a store and know the shortcut has a lot of traffic and takes longer than the normal one. So we always take the normal one, because he is faster.
g3
Electricity takes the path of least resistance. When the electricity travels outside of the circuit, rather than through it, it is called a short circuit.
Shorter because its orbit is smaller and its takes less time to complete its round around sun
The word that means "takes place" is "occurs."
A motor takes electricity and creates rotating motion. A generator takes rotating motion and turns it into electricity.
you were probably just spotting. if you haven't had very many periods before, you may have some close together, and some far apart. it takes a while for them to get regular