0
Schmitt trigger converts any type of waveform (such as sine,triangular.........)to square wave.So it is called Square wave converter.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is TPZi waveform?
A saw tooth wave form superimposed over a square wave form is TPZi wave form. Most of the Inverters use this technology instead of pure sine wave form of out put.
What is required to convert an analogy sound wave into digital form?
What one needs is a bit of hardware circuitry called a Analogue to Digital Converter (ADC). These work by sampling the analogue electrical waveform.
What is need of rectifier in electronics?
rectifiers are used in electronics to convert the sine wave into its +ev side only.there are two rectifiers half wave and full wave rectifier half wave take +ev of only one cycle and full wave rectifies whole cycle to its +ve.
What is the form factor of sine wave?
Form factor is (RMS value)/(average absolute value) For sine wave form factor = (1/sqrt(2))/(2/pi) = about 1.11
In electrical engineering what is form factor?
Form factor of an alternating current waveform (signal) is the ratio of the RMS (Root Mean Square) value to the Absolute Average Value (also referred to as the Practical Average Value) of the waveform.In the case of a sinusoidal wave ie., an analogue wave, the form factor is approximately 1.11.In the case of a square wave ie., a digital wave, the RMS and the average values are equal; therefore, the form factor is 1.
What is the application of schmitt trigger?
Square wave generator
How schmitt trigger and square wave generator differ in their output waveform?
Yes,schmitt trigger has upper and lower threshold voltage for the reason of noise protection while square wave generator doesn't have these properties.
Why does a Schmitt trigger circuit form a square wave at its output for any input wave?
A Schmitt trigger is a comparitor circuit that is basically an on-off switch. It's either on or off (which we call high or low). Once a threshold at the input is exceeded, it turns on, or goes high. Below the threshold, it turns off, or goes low. Drive a Schmitt trigger with whatever you want. It responds in only two ways; high or low. It has no other output states.
Explain how a square wave is produced from a sinwave?
Use a Schmitt trigger. You can buy one of these as an I.C.
What is the three types of wave forms in trigger circuit of oscilloscope?
The three waveforms in the trigger circuit of an oscilloscope are the sine wave, square wave and saw tooth wave.
Is AC a wave or a wave form?
wave form
What does a microwave convert electrical energy into?
Electricity is converted into the electromagnetic wave called a microwave.
What happens to the energy from tsunami after that tsunami strikes land?
The energy dissipates, meaning that as the wave breaks, it will eventually convert to heat.The energy dissipates, meaning that as the wave breaks, it will eventually convert to heat.The energy dissipates, meaning that as the wave breaks, it will eventually convert to heat.The energy dissipates, meaning that as the wave breaks, it will eventually convert to heat.
How many ammperes in 3500watt?
how squre wave convert into sine wave incase of inverter
What is a wave a form of?
Electromagnetic wave
How do you produce delay in square wave signal?
It depends on how much delay you want, and also on the frequency. If you just need a few nanoseconds, run the square wave through an even number of series connected inverters. If you need 180 degrees, run it through one inverter. If you need something else, you may need a more complex solution, ranging from an RC coupled schmitt trigger to a digital phase locked loop.
What is TPZi waveform?
A saw tooth wave form superimposed over a square wave form is TPZi wave form. Most of the Inverters use this technology instead of pure sine wave form of out put.
