source
If become easier to lift a load in a wheelbarrow when the load is towards wheel why
when source resistance and load resistance are equal maximum power is transfered
As the circuit must be a closed loop, the current passes through both the source and load. If it was not a closed loop no current could flow anywhere.
The voltage appearing across a load is always smaller than the no-load voltage of any voltage source -e.g. batteries, generators, or transformers. In simple terms this is because all these voltage sources have internal resistance or impedance which results in an internal voltage drop when the source delivers a load current. The resulting voltage, therefore, is always the difference between the no-load voltage and the internal voltage drop. A measure of the difference between a source's no-load and full-load voltage is termed its 'voltage regulation'.
50%
If become easier to lift a load in a wheelbarrow when the load is towards wheel why
A:is equal to the source
The above example is considered a load because it consumes energy from the source it is connected to. It draws power from the source to operate or perform its function. In contrast, an energy source is a provider of energy that can supply power to a load.
In electrical circuits, a hot wire carries the electrical current from the power source to the device, while a load wire carries the current from the device back to the power source. The hot wire is typically black or red in color, while the load wire is usually white or gray.
when source resistance and load resistance are equal maximum power is transfered
For maximum power transfer, source resistance should match load resistance and source reactance should match load reactance with the opposite sign (so if the load is capacitive, the source should be inductive).
As the circuit must be a closed loop, the current passes through both the source and load. If it was not a closed loop no current could flow anywhere.
source
A: That will happen anytime the voltage source is not able to provide the power needed for the load. If the load exceed the power available from the source the voltage will be reduced as IR drop from the source
conventional current flow means the natural tendency of a current to flow ie)source to load,towards low resistance,higher potential to lower potential
A static market where one buyer faces a whole load of sellers.
The higher the mismatch between the load impedance and source impedance, the higher the loading effect.