disadvantage of current meter
current is measured with the meter in series and voltage is measured with the meter in parallel of the load
Ammeters (amps) An Ammeter is a meter for measuring electrical current, the unit of which is the Ampere (amp)
It measures current by creating a coil around the current carrying wire. Current flowing in the wire induces a current in the amp-meter proportional to the current flowing in the wire.
If the circuit is carrying current then that means that the load (resistance) is in the circuit. if an ohm meter is connected in the live circuit then there would be some voltage drop at the ohm meter but as the meter has very less resistance, this would damage the instrument.
disadvantage of current meter
Electrical current is measured with an "ammeter". (The unit of current is "ampere". Measure it with an 'ampere-meter' ==> 'amp-meter' ==> 'ammeter'.)
current
j
ANY METER needs some kind of current flow to operate. Internal in the meter there are batteries that provide current that when passed trough a resistor will develop voltage as a function of the current. the meter will read this current and display the resistor size to cause this current to flow.
A: Directly from whatever you are measuring as a Small current to move the coil to indicate current flow. That current can be calibrated to read voltage or current on the meter itself
The Amp meter was design to allow current flow through the meter to measure with a minimal alteration to the original circuit. That is the ideal world, in reality the meter has some resistance and will lower the current flow. The multiple current setting on most meter will reduce the effects caused by the meter but you must be careful not to damage the meter by reading to high for the setting.
The Amp meter was design to allow current flow through the meter to measure with a minimal alteration to the original circuit. That is the ideal world, in reality the meter has some resistance and will lower the current flow. The multiple current setting on most meter will reduce the effects caused by the meter but you must be careful not to damage the meter by reading to high for the setting.
A meter can be used both on the positive or negative side of a circuit when measuring current. The current going to a load should be equal to the current coming back from the load. When measuring DC current, make sure the meter should be more than adequete to be placed in series with the circuit. Otherwise, use a clamp-on meter.
current is measured with the meter in series and voltage is measured with the meter in parallel of the load
You can measure the electrical current with an amp meter. Amperage measures the current flow.
A common meter cannot withstand high voltage current if it is not rated to do so it will be damaged due to excessive current