The mains lead in a strip heater serves as the primary power supply connection between the heater and the electrical outlet. It is typically a flexible insulated cable that carries the electrical current from the source to the heating element within the heater. The mains lead is essential for providing the necessary power for the heater to generate heat and maintain the desired temperature. It is important to ensure that the mains lead is properly connected and in good condition to prevent any electrical hazards or malfunctions.
Your circuit breaker shuts off when you turn on your heater because the heater draws a significant amount of electrical current, potentially exceeding the circuit's capacity. This overload causes the breaker to trip as a safety measure, preventing overheating and potential fire hazards. Additionally, if there are any underlying electrical issues or faulty wiring, this could also contribute to the breaker tripping. It's advisable to consult an electrician to assess the situation.
The holes on the back are there for quick wiring. You strip the wire and then insert it into the holes. It is held in place by spring tension. I do not recommend you wire the outlet by using these holes. From my experience the wires are not secure enough. Strip the wire and wrap it around the screws and tighten it securely which is what all the good electricians I know do. Takes a little longer but IMO it is more secure.
The ballast for strip lighting is in the wire raceway. Strip lighting is bolted together in sections. Every section has a ballast for ever set of lamps that hang below the wire way. When wired, these ballasts are all parallel connected together and when sourced with voltage they will all come on at once. The whole strip of lighting will illuminate.
Yes, you can change a power supply from a night storage heater to an ordinary power socket, but it should be done by a qualified electrician. The wiring and amperage requirements for night storage heaters are different from standard sockets, so it's essential to ensure that the circuit is suitable for the new use. Additionally, local electrical codes and regulations must be followed to ensure safety and compliance.
It is an electric heater, with the heating elements in a straight line (a strip)
Perspex can be softened and shaped using a strip heater. The strip heater heats the Perspex material to a malleable state, allowing it to be bent or formed into the desired shape.
A strip heater is typically used to heat surfaces for applications like plastic bending or sealing. To use a strip heater, you would place the object to be heated on top of the strip heater and turn it on. The heat generated by the strip heater will soften the material, allowing it to be formed or sealed as needed.
A strip heater typically does not have a built-in limit switch as part of its basic design. However, limit switches can be used externally in a heating system to monitor and control temperature, ensuring that the strip heater does not exceed a predetermined safe temperature. This can help prevent overheating and potential damage. For specific applications, it's advisable to check the manufacturer's specifications or consider integrating a limit switch for enhanced safety.
bending acrylic
The most obvious health and safety issue connected with strip heating is the possibility of fire.
Restaurant and bar supply retailers would be a possible place that you could purchase a hot strip heater. Web restaurant store has their own website which would be your best bet for purchasing a hot strip heater.
1:Tie back long hair and secure loose clothing 2:Wear an apron 3:Wear safety glasses 4:Don't leave it on unattended 5:Wear leather gloves
A strip heater
Say you have water travelling through tubes, and you wish to heat that water as it goes... Attaching a strip heater around that tube would enable you to regulate the temperature of the water passing through.
A Hot Wire Strip Heater
Yes, I know how to properly install a water heater strap for safety purposes.