Depends on the waatage of the immersion heater. Read the name plate details of the heater - it shows the wattage of the heater. Assuming the wattage is 1KW (1000Watt) the KHW will be 1KHW if you use the heater for 1 hour.
The paraffin heater is gas powered. It is not a very safe heater to use as time has proven that they are very dangerous and can overheat or even explode in some circumstances.
A ceramic heater uses the same amount as a regular heater. Most heater use 1500 watts so in one hour a 1500 watt home heater will use 12.5 amp hours.
Assuming it is a 208-volt line voltage (as normal in 3-phase) the phase voltage is that divided by sqrt(3), or 120 volts. Each phase has to supply 10 kW so the current on each phase is 83.3 amps.
It's called a magnetic strip for a reason, and usually checkouts that use anti-theft devices will have a sign that says keep magnetic strips away from a certain area (the cashier usually rubs the item over the area to disable the device). You can do the same thing. Use a strong magnet, and rub it several times over the strip.
It is an electric heater, with the heating elements in a straight line (a strip)
Perspex can be softened and shaped using a strip heater. The strip heater heats the Perspex material to a malleable state, allowing it to be bent or formed into the desired shape.
how to use a strip heater is simplez dont burn yourself and keep your hands away from the hot metal bar so its simplez compare the Meerkats.com
Say you have water travelling through tubes, and you wish to heat that water as it goes... Attaching a strip heater around that tube would enable you to regulate the temperature of the water passing through.
bending acrylic
Restaurant and bar supply retailers would be a possible place that you could purchase a hot strip heater. Web restaurant store has their own website which would be your best bet for purchasing a hot strip heater.
A strip heater
As long as you have a heater strip installed on the compressor, you will not have a problem.
A Hot Wire Strip Heater
1. You use a Laser Cutter to cut the acrylic plastic out. 2. You use a Strip heater to bend the acrylic 3. You use 2D Design V2 to design the vase
over 100 degrees c so don't touch it.
The mains lead in a strip heater serves as the primary power supply connection between the heater and the electrical outlet. It is typically a flexible insulated cable that carries the electrical current from the source to the heating element within the heater. The mains lead is essential for providing the necessary power for the heater to generate heat and maintain the desired temperature. It is important to ensure that the mains lead is properly connected and in good condition to prevent any electrical hazards or malfunctions.