They can be many different colors, shapes and sizes. To identify whether a capacitor is directional or not, you must look at the markings on it - if it is directional, it will have a little +, and possibly a - to denote directionality (some only have the + I believe due to size).
In general, electrolytic capacitors are normally directionalized. These are the capacitors that resemble batteries in shape, and usually have an 'X' on the bottom (this creates a weak point in the casing; if the capacitor overheats for whatever reason - overvoltaging, or revers polarizing- the 'X' will fail first).
Capacitors are rated in Microfarads
While most electrolytic capacitors are the ones that have a polarity noted as minus "-" and "+" as opposed to ceramic or film capacitors, it's important to note that even electrolytic capacitors could also be labelled as "np" for non-polarized or "bp" bi-polarized, which means the same thing, that there is no plus or minus and the current can flow in both directions. Today a good quality electrolytic, most of the time, will be another color to depict this such as green for example, whereas in older circuits they could sometimes look identical but just be missing the little "-" indicator. So, you need to pay attention to this little detail on older boards when replacing a capacitor.
The directional part. Directional relays will operate for events "in front of" them, but will not operate for events "behind" them. Typically directional relays are used in non radial situations such as on the bulk electric system. Non-directional overcurrents are commonly used on radial lines.
Gang capacitors are a series of capacitors that are mounted to a common location. When they are mounted in series, they can be controlled by a single switch instead of multiple ones.
The type of dielectric most often used in variable capacitors is air. Also, trimmer capacitors often use mica.
Yes..... its like the resistor color code
You see the way a relay operates really is just simple physics. These physics are operated with the use of "Flux Capacitors". Flux capacitors are used in nearly every single circuit and have potential to break the space time continuim. The device containing the most potential of "Flux capacitors" is the Continuim Transfunctioner. A diagram of this ultimate device has been seen in a Documentary "Dude Where's my car?".
The capacitors those are polarity sensitive are called electrolytic and tantalum capacitors. These capacitors are labeled as positive and negative.
directional
Capacitors are rated in Microfarads
because normal capacitors does not have any polaririties.
Film capacitors cannot be replaced with ceramic or mica capacitors if used for analog signal processing. However, mica capacitors can be replaced with ceramic capacitors in general.
is address bus uni or Bi-directional
omni-directional is the opposite of directional. A directional antenna receives or sends more signal from or to the front than the sides or back.
Replaced capacitors that are no lomger capacitors.
Mostly the leakage of capacitors is due to the resistor.
Nokian Capacitors's population is 290.