The formula you are looking for is Amps = Watts divided by Volts. Once you find the amperage you can decide as to the size of a fuse you should use. Remember that fusing protects the conductors of the circuit and not the load of the circuit. A #14 wire is rated at 15 amps and can legally be loaded only to 12 amps.
Yes. It just won't be as bright.
40 watt light bulb. This is obvious. Go do an experiment. -_-
Yes, you can run a 400-watt metal halide (MH) bulb in a 600-watt high-pressure sodium (HPS) fixture, but you need to ensure that the ballast is compatible with the MH bulb. Using a 400-watt MH bulb in a 600-watt ballast may lead to reduced efficiency, as the ballast will deliver more power than the bulb requires. It's essential to check the ballast type and ensure that it can operate both bulb types safely. If not compatible, it's best to use the appropriate ballast for the MH bulb to avoid damaging the bulb or the fixture.
A 120 volt table lamp with a 75 watt bulb will pull 0.625 amps. With a 100 watt bulb it will pull 0.833 amps. And with a modern fluorescent 13 watt bulb it will pull 0.108 amps.
No, a 175-watt metal halide bulb should not be used in a 100-watt ballast fixture. The wattage of the bulb must match the ballast's rating for optimal performance and safety. Using a bulb with a higher wattage than the ballast can lead to overheating, reduced lifespan, and potential damage to both the bulb and the ballast. Always ensure compatibility between the bulb and ballast specifications.
yes, it can be used - single phase voltage of 230v. 50HZ is important
A 13-15 watt compact fluorescent bulb (CFL) or a 9-11 watt LED bulb is roughly equivalent to a 60 watt incandescent bulb in terms of light output.
Fuses are not rated in wattage, they are rated in amperage and voltage.
To calculate the minimum fuse rating needed for a 36W bulb on a 12V circuit, divide the wattage by the voltage (36W / 12V = 3A). Therefore, a minimum 3A fuse would be sufficient for a 36W bulb on a 12V circuit.
No. A 70 Watt metal halide bulb can not be replaced with a 150 Watt halide bulb.
It is not recommended to use a 67 watt bulb in place of a 60 watt bulb as the higher wattage could potentially cause overheating issues. It is best to stick with the recommended wattage for the fixture to ensure safety and proper functionality.
100
It is possible for a 150 watt halogen bulb to blow a fuse if it draws more electrical current than the circuit can handle. It is important to check that the circuit can support the wattage of the bulb to prevent overload and potential fuse blowing.
The main difference between a 100-watt and a 75-watt light bulb is the amount of light output they produce. A 100-watt bulb will be brighter and consume more energy compared to a 75-watt bulb. The 100-watt bulb may also generate more heat than the 75-watt bulb.
this is a highly complex issue becuasu the bulb is the important part of a lamp. so i personally feel after much research and condsideration i feel that i bulb with a 75mm fuse would be highly reccommended :) thankyou for testing my knowledge.
The brightness level of a 5 watt LED bulb is equivalent to a 40 watt incandescent bulb.
The brightness level of a 25 watt LED bulb is equivalent to that of a 100 watt incandescent bulb.