base spreading resistance is the resistance which occur at the base of transistor dis is becoz of varying base voltage
Base spreading resistance depends on doping of the p-n junction and also the width of depletion region of the p-n junction. Thats what i knw.
The bulk resistance between the two bases, which will be different for different types of UJT. Consult the datasheet for the value.
A lightning arrester (or lightning rod) works by providing a low resistance path to earth. This directs a lightning strike down the side of a building instead of it spreading through the electrical system.
The input current of transistor is approximately equal to output current .Suppose in common base configuration the emmiter current is approximately equal to collector current if neglect the very small value of bae current.Even though the input resistance is not equal to output resistance,the currents are same ,so we can reliase that the transistor transfers resistance to get same currents at both ends.
B - Dynamic resistance
Base-spreading resistance refers to the resistance that exists in a bipolar transistor due to the spreading of the base current into the collector region. This resistance can limit the transistor's high-frequency performance and impact its overall efficiency. Reducing base-spreading resistance is important for improving the speed and performance of a transistor.
Base spreading resistance depends on doping of the p-n junction and also the width of depletion region of the p-n junction. Thats what i knw.
The base unit of resistance is measured in ohms.
It would not stop spreading in space, because of lack of gravity and wind resistance.
The base magic resistance in DotA is 25%.
Resist
Base resistance (Rb) is the resistance seen by the base terminal of a transistor when analyzing its behavior in a circuit. It is a parameter used to model the input impedance of the transistor and is crucial in determining the biasing and signal amplification characteristics of the transistor circuit.
The source of antibiotic resistance is often plasmids known as R plasmids, which carry genes that confer resistance to antibiotics. These plasmids can be transferred between bacteria, spreading antibiotic resistance throughout microbial populations.
(Electronics) Resistor placed in the emitter lead of a transistor circuit to minimize the effects of temperature on the emitter-base junction resistance and its resistance is called swamping resistance.
Maybe you ought to not take emitter and base into consideration prior to concluding
Liquid resistance to spreading out is described by its surface tension, which is a measure of the cohesive forces between molecules at the liquid-air interface. High surface tension means the liquid resists spreading out and tends to form droplets, while low surface tension allows the liquid to spread more easily.
The base units of the ohm are the volt and the ampere. In the context of electrical resistance, the ohm is defined as the resistance that limits the flow of electric current when one volt is applied across it and one ampere of current flows through it.