The input current of transistor is approximately equal to output current .Suppose in common base configuration the emmiter current is approximately equal to collector current if neglect the very small value of bae current.Even though the input resistance is not equal to output resistance,the currents are same ,so we can reliase that the transistor transfers resistance to get same currents at both ends.
Because they are different transistors. Resistance among their internal diodes is one of the main features of a transistor.
Collector-to-Emitter resistance is high when the transistor is biased off.
base spreading resistance is the resistance which occur at the base of transistor dis is becoz of varying base voltage
A transistor is often referred to as an oscillator because of its ability to transfer resistance. it can also switch off and on repeatedly, mimicking an oscillator.
Because in this device the resistance between two terminal respectively collector and emitter is changed by changing the base voltage that is it transfers the resistance between emitter and collector therefore it is called as TRANSISTOR. (TRANSFER OF RESISTOR)
Transistor=Transfer+Resistor. When Transistor operates in active region its input resistance is high and output resistance is low. So,We can consider transistor as a device which transfers its resistance from high to low. And by this property transistor amplifies input signal.
Because they are different transistors. Resistance among their internal diodes is one of the main features of a transistor.
transistor. This word is a blended form of transfer of resistor. The legs of transistor (collector, emitter,base) transfer the resistance. So it is called as transistor
Collector-to-Emitter resistance is high when the transistor is biased off.
In a transistor a current from low resistance input circuit is transferred to a high resistance output circuit with almost unchanged magnitude. This results in a power gain. Infact the name 'transistor' is coined from 'transfer resistor'
r parameter is resistance parameter
base spreading resistance is the resistance which occur at the base of transistor dis is becoz of varying base voltage
the name itself we can say that the transistors are used to transfer from low resistance to high resistance.
(Electronics) Resistor placed in the emitter lead of a transistor circuit to minimize the effects of temperature on the emitter-base junction resistance and its resistance is called swamping resistance.
A transistor is often referred to as an oscillator because of its ability to transfer resistance. it can also switch off and on repeatedly, mimicking an oscillator.
"Transistor" name itself revels it transfers resistance from its input to its output (Transfer of resistance). Input resistance varies when input voltage varies, similarly output resistance varies and this leads to voltage variation at the output. Thus input to output voltage variation is called amplification. this is how transistor can be used as an amplifier. If input voltage is minimum output voltage becomes maximum i.e. its output resistance becomes maximum in common emitter configuration. Thus if no voltage is applied at the input its collector resistance becomes infinite or as if open circuit. Similarly if input current is increased output current increases and out put can behave as short circuit. This is how output current can be switched off or on using no input current or with minute input current. Unlike a digital device, the transistor is an analogue device which can be switch on/off to maximum or any gradient in between. Providing a small AC voltage to the base creates an amplified analogue of this signal across the emitter and collector.
Because in this device the resistance between two terminal respectively collector and emitter is changed by changing the base voltage that is it transfers the resistance between emitter and collector therefore it is called as TRANSISTOR. (TRANSFER OF RESISTOR)