10amp
Answer for USA, Canada and countries running a 60 Hz power supply service. 230 to 240 volts on any size two pole breaker on single phase installations. The voltage varies from location to location from different utility power companies.
The power factor of a load is the cosine of the angle by which the load current lags or leads the supply voltage. So if they are in phase (phase angle is zero), then the power factor must be unity (1).
Sounds as though you only ran a 110 volt power supply to your new shop subpanel. You need to supply 220V with a neutral and ground from your main panel to your subpanel. The 220 supply needs to come from a two pole 220V circuit breaker in your main panel. (example 50 or 100 Amp) Then, most importantly, you must use the correct size wire to carry the current. That is the wire must be sized correctly to the 220V breaker. The neutral must also be the same size as the conductors. Once you determine how much power you need in your shop, size the supply 220v circuit breaker and wire accordingly. Check with your local building department if you are unsure or what size wire to use with what size breaker or refer to Table 310-16 in the National Electric Code. In Australia domestic power is 240v So you have run single phase power to a three phase switchboard. To get power to those breakers you must hook the active to the busbar connected to those circuit breakers.
Assuming your power supply is 230 volts, single phase: Full load amp draw = 21, circuit breaker = 50, minimum wire size = 10.
A TPN MCCB is a three phase neutral molded case circuit breaker. This type of circuit breaker is commonly used in low voltage power distribution systems.
3 Phase power is supplied by a 3 pole supply like a breaker. So essentially yes.
I=270000/380/1.732 I=410A USE: 500A CIRCUIT BREAKER
If there is no neutral available you cannot, unless you use an autotransformer and derive a neutral. A panel with no neutral is called a power panel and is used to supply 240 single and three phase loads.
With no three phase power supply you can't use a three phase motor of any kind at all!
You don't. A three phase motor will not start unless it is connected to a three phase supply.
Bcoz in single phase if supply is interrupt or any trouble there is no power .but in 3 phase if 1phase supply gone we can manage it by other 2 phases
Answer for USA, Canada and countries running a 60 Hz power supply service. 230 to 240 volts on any size two pole breaker on single phase installations. The voltage varies from location to location from different utility power companies.
It won't supply any power.
A single phase supply can operate a three phase motor with a static converter. No a power supply of computer cannot be fed through the static converter.
The power supplied by a three-phase supply, or any supply come to that, is determined by the LOAD, and not by the supply. So you must look at the data provided on the equipment's nameplate to find out what its power rating is.
Yes of course!! 10 kva electrical power is 10 kva electrical power either it would be three phase or single phase. But other factors i.e. current, voltage changes accordingly. Actually this question is quit confusable. Because in 3phase system, if each phase gives 10kva power (single phase power = 10 kva) then 3 phase power will be 10 X 3 = 30 Kva If we go leteratualy towasrds the question, then the asnwer will be - No. becasue 10 kva supply to 3 phase load will be 3phase supply(i.e440V) & 10kva supply to single phase load will be single supply (i.e 250V).
400