Common base transistor if the emitter is open current Ie=0 but a small collector current thus exist.this current is reversed biased collector to the base voltage it is represented by Icbo while common emitter is d base terminal is open circuit and the base junction is reversed biased current Icbo flow from the tcollector to the emitter in the external circuit this current is called leakage current.
With a common emitter amplifier it's the emitter that is usually grounded.
common-emitter
I think you mean a common emitter amplifier, which is an amplifier of voltage. Emitter-follower or common collector amplifiers are used to match impedances, or to amplify power or current. The emitter-follower is a type of common emitter circuit that has a resistor between the emitter and ground. The output signal is taken from the point between the emitter and its resistor.
Common Emitter Configuration has maximum impedance.
because in ce configuration value of input voltage requried to make the transistor on is very less value of the output voltage or output current
The emitter resistor in a common emitter configuration provides negative feedback to the transistor, reducing both its voltage gain and distortion.
With a common emitter amplifier it's the emitter that is usually grounded.
cascade: the output of one amplifier stage is connected to the input of another amplifier stages, it's also connected in series. cascode: it said to be cascode, when it has one transistor on the top of another where a common emitter transistor drives a common base transistor.
pnp transister in common emitter mode
common-emitter
ITS AN NPN TRANSISTOR , GENERALLY USE AS A SWITCH GENREALLY IN COMMON EMITTER CONFIGURATON
I think you mean a common emitter amplifier, which is an amplifier of voltage. Emitter-follower or common collector amplifiers are used to match impedances, or to amplify power or current. The emitter-follower is a type of common emitter circuit that has a resistor between the emitter and ground. The output signal is taken from the point between the emitter and its resistor.
because amplifiers are speakers
A transistor is made up of two diodes back-to-back. In a common base circuit - the load is shared between two diodes
This is a particular transistor amplifier configuration. In general, the input signal is applied to the base, the collector is connected to a supply voltage, and the output is taken between the emitter and power supply common. One of the characteristics of the emitter follower is the output voltage "follows" the input, but the output is reduced by the Vbe voltage (the voltage drop between base and emitter, approximately 0.7 V for a silicon bipolar transistor).
Common Emitter Configuration has maximum impedance.
Common Emitter - Class A Amplifier.