rf is a single tuned amplifier . Its functions are :-
1.improves selectivity ( i.e rejection of unwanted signal) , so that it prevents heterodyning which results in interference frequency.
2. improves image frequency rejection
3. improves sensitivity ( gain of amplifier )
4.improves coupling of receiver with antenna .
5. improves signal to noise ratio.
6. reradiation of local oscillator through receiver antenna is prevented
Selective amplifier is an RF amplifier which selects particular frequency and amplifier so it can operate at fixed frequency.
That depends on its purpose. Some examples:RF amplifier in IF stage of AM radio: 10KHz.RF amplifier in TV set: 6MHz.RF amplifier in IF stage of FM radio: 200KHz.An RF amplifier in a military RADAR set will probably have very narrow bandwidth to reduce jamming possibility, but wide enough to allow for doppler shift of targets.
If an RF amplifier amplifies the incoming signal by 200 times, the power gain of the amplifier is +25.9 dB. Power is proportional to voltage squared, so the power gain is 400. The decibel scale is 3 times log2 of the power change.
A: The small base current will control the collector current flow by adding a resistor this changes of current flow will be evident as a voltage amplifier.
GAIN is a function of load current but basically a small current in the base will make a big change of collector current therefore making a transistor a voltage amplifier as opposed to a current amplifier
The amp for audio freq. is a AF amplifier. The RF amp is for radio freqs.
the approximate efficiency of a class b linear RF AM amplifier is 35%
A unidirectional amplifier & a Bidirectional amplifier
A RF amplifier is a device for electrically amplifying the power of an electrical signal, typically, but not exclusively, radio frequency signals.
The answer to whether an RF power amplifier is useful for your home depends on the qualifty if your equipment. If your T.V. is getting a weak signal for example, an RF power amplifier may be useful to get a better signal.
Selective amplifier is an RF amplifier which selects particular frequency and amplifier so it can operate at fixed frequency.
class C
That depends on its purpose. Some examples:RF amplifier in IF stage of AM radio: 10KHz.RF amplifier in TV set: 6MHz.RF amplifier in IF stage of FM radio: 200KHz.An RF amplifier in a military RADAR set will probably have very narrow bandwidth to reduce jamming possibility, but wide enough to allow for doppler shift of targets.
If an RF amplifier amplifies the incoming signal by 200 times, the power gain of the amplifier is +25.9 dB. Power is proportional to voltage squared, so the power gain is 400. The decibel scale is 3 times log2 of the power change.
The intermediate frequency (IF) amplifier lies between the mixer and the demodulator. The mixer shifts the input radio frequency (RF) signal into the range of the IF amplifier. The IF amplifer is a band pass amplifier, so only RF signals that are the IF frequency distance away from the local oscillator in the mixer can pass through to the demodulator. This process is called the superhetrodyne process.
09. A tuned RF amplifier is
I think you mean a (TV antenna amplifier) RF amplifier used with coax cable. The answer is YES it will work with DTV.