the energy in the area is called ME-Kos.
What is the voltage in your area?
What is the voltage in your area?
What is the voltage in your area?
for given power,High voltage transformer requires more insulation in window from phase to phase and phase to core.Amount of insulation in window increases and net copper area will decrease,Window space factor=(Net copper area in window/window area)Kw = Ac/AwHence, with increase in voltage rating,net copper area decreases and ultimately window space factor reduces.
if that 144 is the peak voltage if its a sine wave the rms voltage is that voltage divided by sqrt(2) if not a sine wave (modified) you must find the area under the curve by integrating a cycle of that wave shape (root mean squared)
Because the voltage/current curve is not as steep as we would like and because the diode is too sensitive to thermal effects in this area.
Voltage is the potential difference between the source & any point in the circuit. The forward voltage is the voltage drop across the diode if the voltage at the anode is more positive than the voltage at the cathode (if you connect + to the anode). Voltage drop means, amount of voltage by which voltage across load resistor is less then the source voltage.
Voltage gain is the ratio of the output voltage of an amplifier to its input voltage.
cross sectional area of cable * voltage drop
It does :)
The voltage drop in a wire has nothing to do with the insulation. Voltage drop has to do with the cross sectional area of the wire.
Acknowledge to your self that there is High Voltage in the area and be careful where you trespass or what you touch.
It is not based on the area really... basically for each photo voltaic cell they have a certain voltage, if you connect them in series such as -------0-------0----------0---------0--- then it will increase the voltage 4fold but not the amplitude if they are connected in parallel then amplitude will increase but not voltage. Usually panels have a mix of both to get a good voltage and amplitude |--------0-----| |--------0-----| |-------0------| |------0-------| |------0-------|
Voltage drop can be minimized in a radial distribution by increasing the cross-sectional area of the conductors.
120v, 240v and 347v for lighting
There is no choice of what voltage that you are supplied for your home. You are governed by what the utility company in your area supplies.
The voltage of your area is what determines the operating voltage of all equipment. Equipment from other countries usually has to use a transformer to get the correct voltage. The voltage on a fluorescent fixture is printed on the ballast of the fixture. See if the voltage on the ballast matches the supply voltage of the system that you are going to use to operate the fixture.
for given power,High voltage transformer requires more insulation in window from phase to phase and phase to core.Amount of insulation in window increases and net copper area will decrease,Window space factor=(Net copper area in window/window area)Kw = Ac/AwHence, with increase in voltage rating,net copper area decreases and ultimately window space factor reduces.
if that 144 is the peak voltage if its a sine wave the rms voltage is that voltage divided by sqrt(2) if not a sine wave (modified) you must find the area under the curve by integrating a cycle of that wave shape (root mean squared)
Because the voltage/current curve is not as steep as we would like and because the diode is too sensitive to thermal effects in this area.