answersLogoWhite

0

Timer Overflow is when the timer value exceeds the maximum count it can reach, let say 256 for 8-bit and 65536 for 16-bit timers.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is overflowing?

Timer Overflow is when the timer value exceeds the maximum count it can reach, let say 256 for 8-bit and 65536 for 16-bit timers.


Why does the overflow reservoir overflow?

because the entire point of the overflow resovoir is to overflow, and release uneeded water


Which two Latin words mean overflow?

There are a number of (single) words available, inrigo as in to overflow or irrigate, abundo as in to be abundant and overflow, superfundo as in to flood or overflow, restagno as in to be swamped or overflow, exundo as in to flow out or overflow, adfluentia as in to overflow with abundance


What are the four timers used in TCP?

Connection establishment timer, persist timer, keepalive timer, retransmission timer


When was Clancy of the Overflow created?

The Overflow of Clancy was created in 1892.


What are the common causes of overflow in a bathroom sink with overflow?

Common causes of overflow in a bathroom sink with overflow include a clogged drain, a faulty stopper or drain plug, or a malfunctioning overflow drain system.


Is timer a short vowel?

The i in timer is a long vowel and the e in timer has a short vowel.


How do you clear a stack overflow?

How do you clear a stack overflow


Is there a timer on the blackberry curve?

it depends on if you mean a camera timer or an overall timer.. if an overall timer then yes. if a camera timer then no, none of the blackberry's have a timer for your camera. but if you go on app world and type in "nux shoot" you will get one, it is completely free and great.


What is interrupt for 8051?

An interrupt in the 8051 microcontroller is a mechanism that temporarily halts the execution of the main program to allow the processor to address an event or condition that requires immediate attention, such as a timer overflow, external signal, or serial communication. The 8051 supports multiple interrupt sources, including external interrupts (INT0 and INT1), timer interrupts (Timer 0 and Timer 1), and a serial communication interrupt. When an interrupt occurs, the microcontroller saves the current program state, jumps to a predefined interrupt service routine (ISR), and upon completion, resumes the original program. This allows for efficient handling of asynchronous events without continuous polling.


What would happened if you wired a 240v ballast and a 120 v ballast into a heavy duty timer?

The timer has to be multi-pole. The ballast must be connected to the load contacts of the timer. If the timer is a 120 Volt timer, the timer has to run on a 120V. circuit. Loads are loads, and as long as you have a multi-load timer you can hook up whatever you want. If the timer only works on a shared power source (load shares the timer supply) you will need to use a contactor on the load side or the timer.


When was Stack Overflow created?

Stack Overflow was created in 2008.