Variable DC power supply is:
Variable - you can adjust it
DC - direct current, electrons (electricity) flows in only one direction
power supply - power supply
Together, it's an adjustable one-way power supply
Hope you find this useful...
Variable dc supply is applicable in loads that are variable.
dc supply is used for control circuit because dc current is an independent source .
conclusion of dc power supply 9V
In an ideal DC power supply, there is no ripple.
DC 12V power supply can convert 110/220V AC power source to 12V DC.
Variable dc supply is applicable in loads that are variable.
Variable DC power supplies are commonly used in electronics labs, production lines, and testing environments. They are used to power and test electronic devices such as electrical components, circuits, and sensors. Variable DC power supplies are also used in research and development for prototyping and experimenting with different voltage levels.
You can purchase a variable DC power supply online from retailers such as Amazon. Once on the website, type "Variable D/C Power Supply" into the search field at the top of the page and press enter to bring up the items.
The speed of a dc motor can be regulated by the following means:By varying the supply voltage and byUsing a variable rheostat.
no... run tv with dc supply
You could try using a simple variac to make the power supply from 220 V AC to 300 V DC variable adjustable. This will work just fine if you don't have a workable circuit.
A variable power supply has a control to adjust the DC output voltage from 0 to 12 volts. It is used for testing electric project's such as amplifiers and other electric devices. It can be used to replace other fixed voltages power supplies such as the srandard 3 volt, 5 volt, 9 volt and 12 volt units.
Dc chopper is a static device which converts constant dc source to variable dc.
It may not be possible to physically convert AC generator to DC generator. What can be done is that 'Rectifier' of suitable capacity can be connected to the out put of AC generator to get DC supply.
Connect a variable resistance across DC source (fixed ends of variable resistor or Rheostat) and take decreased DC output across its one fixed terminal and other variable terminal of variable resistor. Other method is connect variable resistor in series with DC output and load, vary the resistance and take decreased DC voltage as required.
The transformer cannot be used in the DC supply because it keeps on alternating its current, whereas the DC supply current should be constant.
Dc chopper is a static device which converts constant dc source to variable dc.