Voltage amplitude is the maximum value of a voltage.
Amplitude
Yes.
Conversions of RMS voltage, peak voltage and peak-to-peak voltage. That are the used voltages. The expression "average" voltage is used for RMS voltage.Scroll down to related links and seach for "RMS voltage, peak voltage and peak-to-peak voltage".Answer'Average' is not the same as 'root mean square'. As the average value of a sinusoidal voltage is zero, you cannot convert it to a peak-to-peak value.
that is called solar cell which converts light(photons) to D.C voltage .the amplitude of voltage depend on how many solar cell are you joined in seies a solar cell normally produce 0.6-0.7 V D.C
ANSWER: The peak to peak voltage can be found by multiplying 120 v AC x 2.82= 339.41
Amplitude
Amplitude Modulation voltage
Voltage Ampere or Voltage Amplitude
The relationship between the amplitude of muscle response and the voltage of the stimulus is generally linear. As the voltage of the stimulus increases, the muscle response increases in amplitude up to a certain point. Beyond that point, further increases in voltage may not significantly increase the muscle response amplitude or could lead to muscle fatigue or damage.
It is the highest value of the amplitude, called the peak value. Scroll down to related links and look at "RMS voltage, peak voltage and peak-to-peak voltage". Look at the figure in the middle below the headline "RMS voltage, peak voltage and peak-to-peak voltage".
first we connect the oscilloscope with the function generator or whatever the source of the input voltage , there will be a wave ,we try to adjust its amplitude using oscilloscope ..and this amplitude will be the peak to peak voltage..putting into consideration how volt/ div while measuring the amplitude
Yes.
To change the amplitude of a triangle wave, you can multiply the output signal by a constant value. Increasing this value will increase the amplitude, and decreasing it will decrease the amplitude. Alternatively, you can adjust the voltage levels or inputs to the waveform generator to change the amplitude.
Amplitude ratio to dB conversion:For amplitude of waves like voltage, current and sound pressure level:GdB = 20 log10(A2 / A1)A2 is the amplitude level.A1 is the referenced amplitude level.GdB is the amplitude ratio or gain in dB.dB to amplitude ratio conversion:A2 = A1 · 10(GdB / 20)A2 is the amplitude level.A1 is the referenced amplitude level.GdB is the amplitude ratio or gain in dB.
Unless otherwise stated, the value of an a.c. current or voltage is expressed in r.m.s. (root mean square) values which, for a sinusoidal waveform, is 0.707 times their peak value. The output of a voltage (or potential) transformer is no different, its measured voltage will be its r.m.s value which is lower than its peak value.
The relationship between stimulus voltage and response amplitude on a single nerve fiber follows the all-or-nothing principle. Below a certain threshold voltage, there will be no response. Once the threshold is reached, there will be a maximal response amplitude without variation with higher stimulus voltage.
Collector modulation is the amplitude modulation in which modulator varies the collector voltage of a transistor.