the impedence should be complex conjugate of an equivalent impedence of the network when viewed from the terminals of the load.
i.e; Z=R-jx
Common Emitter Configuration has maximum impedance.
transformer coupling ensures maximum power transfer is obtained even if the output impedance is not equal to the load impedance
Maximum power transfer happens in a circuit when the resistance of the circuit equals the reactance. Impedance Z = R + jX. At R=X, maximum power transfer happens.
It depends a lot on the application, i would go with low impedance transformers if am using the transformers for distribution as it will really increase the the maximum fault current. If am using the transformers as step up specially for generators or to charge capacitors, using a high impedance transformer is a good idea as it will decrease the inrush current of the system. you have to see your application and decide what fit that best. Mohammad Jaradat Power Generation Project Manager
The Maximum Power Transfer Theorem is not so much a means of analysis as it is an aid to system design. The maximum amount of power will be dissipated by a load resistance when that load resistance is equal to the Thevenin/Norton resistance of the network supplying the power.
Common Emitter Configuration has maximum impedance.
The maximum current that can be drawn from a voltage source is dependent on the impedance of that source, the impedance of the connections to the source, and the energy available from that source.
The impedance of a circuit having an inductance and a capacitance in parallel at the frequency at which this impedance has a maximum value. Also known as rejector impedance.
transformer coupling ensures maximum power transfer is obtained even if the output impedance is not equal to the load impedance
Two reasons. 1...When impedance of source and destination match, power transfer is maximum. 2...If a long transmission line is involved, the characteristic impedance of the line must match the destination impedance, or reflections will occur on the line.
According to maximum power transfer theorem for ac circuits maximum power is transferred from source to load when the load resistance is equal to the magnitude of source impedance. The source imoedance is the thevenin equivalent impedance across the load
Impedance matching is used in electronics to get an electronic device with an input and output source to work. Impedance matching will give the electronic it's maximum transfer of voltage. An example of this are FM radio receivers.
A; it is to match the cable line impedance to the receiver for maximum transfer of energy
To deliver maximum force in a small area.
Z=(R^2+(Xl*Xc)^2)^1/2 impedance equcation
For maximum power transfer, source resistance should match load resistance and source reactance should match load reactance with the opposite sign (so if the load is capacitive, the source should be inductive).
Inherently, the actual impedance seen at the secondary voltage will be different than that seen at the primary voltage. To make things easy, we use symmetrical components, where transformers are reduced to a p.u. (per unit) impedance. 100 x p.u. is equivalent to the percentage impedance you are referring to. When converted to per unit, a transformer has one impedance, not two, so it does not matter whether you are looking through the transformer from the secondary or the primary.