altinator
active region
The two most important ratings for an electrical heater are its rated power and its rated voltage, and these will be printed on a 'nameplate' fixed somewhere on the heater (e.g. '3 kW at 230 V').For the heater to operate at its rated power, it must be subject to its rated voltage. In the above example, the heater will only operate at 3 kW if it is supplied with 230 V.If you know the heater's power (P) and its voltage (U), then you can calculate the rated current (I) it will draw from the supply, using the equation: I = P/U.You can also determine its resistance (R), using the equation R = U2/P.
alternating current
By referring to the manufacturer's characteristic curves for the fuse. There are different curves for different types of fuse (e.g. rewirable, cartridge, etc.). Essentially, these curve will tell you how quickly the fuse will operate for any value of overload current.
watts
The main purpose of earthing electrical circuits is to provide a low-impedance route back to the substation transformer which, in the event of an earth-fault will allow sufficient fault current to flow in order to operate a circuit's overcurrent protection.
Alternating current is used to operate your electrical appliances.
Fuses don't operate anything,you do. fuses protect electrical circuits from overload
Electrical devices use power to operate, but power does not exist without current. Alternately, if current is flowing, power is being stored or used by some electrical device.
An over current relay will operate when current exceeds its design rating. This application is intended protect loads or circuits from excessive current.
Low voltage to operate relay controlling high CURRENT circuits (currant is a dried fruit).
Safety devices used in electrical circuits.AnswerA fuse is an overcurrent protection device, and will operate in the event of a sustained overload current or a short-circuit current.
In a physics sense, none. But in an electrical sense, A LOT. Microchips operate on DC (Direct Current) electricity, typicaly at 12, 5, 3.3, and 1.0-1.5v rails. Computer microchips also may contain hundreds or more of individual circuits, whereas the average house only has a limited number.
the circuit might not operate properly. but shouldn't effect the circuits them self.
An electric motor need to be supplied electricity to operate. It can be made to generate electricity if turned by an outside force when set up correctly.
Electrical conductivity is important because we live in a world that is increasingly run by electronic devices. These devices depend on materials that are electrically conductive to send their signals and operate.
A calculator can only operate as fast as the electrons that carry the current through its circuits. Electrons have mass, and mass can never travel at the speed of light; therefore, calculators do not operate at the speed of light.