answersLogoWhite

0

We will put the arrows in the circuit diagram from negative terminal to the positive terminal🤗🤗

Thanks..................

User Avatar

Anonymous

∙ 4y ago

What else can I help you with?

Continue Learning about Electrical Engineering

Where do you put a switch in a series circuit?

From the standpoint of basic functionality, you can put the switch anywhere. In a series circuit, there is only one path for current flow. If you open the switch, you interrupt that pathway and turn the circuit "off."There may be practical reasons to put the switch in one place or another, however. Sometimes it's put in a particular place in the circuit for manufacturing reasons. In other circuits, safety may dictate that you put the switch in a particular place: in a ground-referenced circuit for example, you may want to put the switch so that one side is at the ground point.


How do you reduce the noise in electrical circuits?

Depending on the circuit, typically a combination of a coil (commonly called a choke) and a capacitor can be put in circuit at multiple places to significantly reduce noise in a circuit.


how many rooms are allowed on one lighting circuit?

Unless you do not have enough space in the service panel it is always a good idea to have each room on it's own circuit. If you want to put 2 rooms on a circuit just make sure those 2 rooms do not overload the circuit and wire it for a 20 amp circuit. Two bedrooms with 8 outlets each and 1 light each is about all you would want on the circuit. I would never put 3 rooms on the same circuit.


Why would you put a fuse on the neutral side of an electrical circuit?

It does not matter what line in (the phase or neutral) is the fuse. In a closed series circuit current in all areas of the circuit is equal. It's best to put the fuses in both wires (phase and neutral) and even better for each individual device in the chain.


Why is a torch switch important in a circuit?

A switch in a circuit will quickly allow you to break the circuit, without changing the wiring. For example, a light switch. By turning a light switch off, you are breaking the circuit and, thus, turning the light off.

Related Questions

In the gas container why do people put arrows in as well as the little circles showing the gas?

The little circles represent the gas molecules and the arrows denote the direction of their motion.


Rectifier How do you change the 2 arrows direction in the circuit to make it positive or negative In Bridge?

A: Actually there is no changing of diodes required to get negative voltage out put the two cathode to ground if you have a load the voltage across will be negative. Electrons only flow in one direction where the measurement point are located across the load makes positive or negative.


Where can a circuit diagram for an electronic power inverter be found?

This is a text-only site and was not designed to show circuit diagrams, but there are lots of circuit diagrams available elsewhere!Just put "power invertor circuit diagram" or similar wording into your favorite web search engine and you'll be given lots of links to them.A link to a very typical circuit diagram for a 12 volts dc to 230 volts ac invertor is given as a Related Link below this answer.


What do you put in a quiver?

Arrows.


Where do you put your arrows?

in a quiver


What is the bag called that arrows are put in?

The 'bag' arrows are carried in is called a quiver.


Can you put quickfletch on aluminum arrows?

I used it on one of my aluminum arrows and it works just fine


Why do my arrows keep shooting right with every sight I put on?

Your arrows have too much spine (stiffness). Get new arrows with less spine.


How do you do arrows on Bebo?

You have to add people who have arrows as their profile photo and then put them in your top 10 friends list.


What to put in the same direction?

Objects or items that are aligned or facing the same way are said to be in the same direction. This could apply to things like arrows, signs, or people walking in a line. It helps create a sense of order and organization in a visual or spatial context.


What do you put your arrows in after you take them out of the target in archery?

the quiver


Where would you put an ammeter in a circuit?

in a series circuit or it will not work. Put it after the bulb