Slip rings provide a means for connecting the rotating armature of a simple a.c. generator to an external circuit. As the armature naturally produces an alternating voltage, an alternating voltages is what appears across the slip rings.
To obtain a d.c. voltage, it's necessary to reverse the direction of the natural alternating voltage every half cycle, producing full wave rectification. This is achieved using a split-ring commutator which, essentially, is a rotating switch.
So, slip rings are used with simple a.c. generators, whereas a commutator is used with d.c. generators.
Having said that, however, large modern a.c. generators (alternators) have fixed armatures, and rotating fields, and slip rings are used to supply d.c. field current to the alternator's rotating field windings.
Slip rings are used in AC while split rings are used in DC generators
slip ring is connect on shaft of motor to collect current from commutator without any complicate connection and with use of it resistors can be insert in circuit and therefore speed control of motor can easily achive
Split rings are in AC generators ( alternating current) while slip rings are in DC current (direct current).
U sohuld replace the slip-ring which it is in the AC generator to a commutator. It is a split-ring. Then u can produce DC generator.
what is the construction of ac generator
They rotate the armature coil.
No. Just the opposite. An AC alternator uses slip rings, a DC generator uses a commutator. Most modern auto alternators are in fact AC alternators that rectify the AC output to DC using a diode bridge.
Slip rings are used in AC while split rings are used in DC generators
because DC generator generates generally generate DC power but as it has slip rings which convert it into ac output power
you apply dc voltage to slip rings in synchronous generators polarity will make no difference ( other than when it is first applied )
slip ring is connect on shaft of motor to collect current from commutator without any complicate connection and with use of it resistors can be insert in circuit and therefore speed control of motor can easily achive
Engine Alternator Cooling and exhaust systems fuel tank voltage regulator control panel
If the commutator is removed from your generator, you (if you connect slip rings) get AC supply instead of DC supply. the function of the commutator is to convert AC to DC supply and vice versa.Additional AnswerRemoving the commutator will also prevent you from connecting the output of the generator to its load. Remember, the generator's armature is spinning!
In a very simple, laboratory-type, a.c. generator -yes. In practical generators, the output (armature) windings are part of the stator, so do not rotate and, so, don't require slip rings.
Split rings are in AC generators ( alternating current) while slip rings are in DC current (direct current).
slip rings
The split rings cause the direction of the magnetic field in the armature to change direction as the motor rotates. If this didn't happen the motor would not rotate. Slip rings can be used for an AC motor which causes the direction of the magnetic field to change with the AC waveform.