1. bec the capacitor not allow the current to pass through it after it has charged & it charged in no time ex:(10^-4 second).
2. because it is necessary to avoid wrong polarity by shorting the terminals of the capacitor and tripping the fuse.
how to connect power capacitor with 3 phase motor
It is called a varactor or a varicap diode. Its capacitance varies nonlinearly with the reverse voltage applied to its terminals.
The Capacitor with running winding is connected in parallel with main winding.
Only frequencies in the pass band range will be allowed through the circuit. Other frequencies will be attenuated based on the RC values picked.
the charge on the capacitor had increased.
To add a capacitor and resistor in parallel, simply connect one terminal of the capacitor to one terminal of the resistor, and then connect the other terminal of the capacitor to the other terminal of the resistor. This creates a parallel circuit where both components share the same voltage.
First you connect a trnsformer to the main supply and then a rectfier .youmay connect a zener diode or a resistor or a capacitor as a filter circuit
varactor diode is a correct answer
No. The purpose of the zener diode is to clip (turn on) at a certain voltage. A capacitor will not exhibit this behavior.
To connect a capacitor in parallel to an AC motor, first ensure the power is off and the circuit is safe to work on. Then, wire the capacitor across the motor's power terminals, ensuring the correct polarity if it's a polarized capacitor. This setup can improve the motor's power factor and efficiency by providing reactive power, which helps reduce energy losses. Always consult the motor's specifications and local electrical codes before installation.
Transistor Diode Resistor Capacitor
You can use a transistor as a diode if you connect the base to the collector. Any forward current through the base-emitter junction would cause a corresponding increase in the available current through the collector-emitter junction. Since the base-emitter and collector-emitter junctions are in parallel, this would effectively be a diode, but a true diode would be a better solution if diode functionality is what seek. A: There are actually two diodes, per se, inside a transistor. The base to emitter diode will suffice. By tying the collector to the base it will in effect be two diodes in parallel.
how to connect power capacitor with 3 phase motor
just like it soundsseries resonant has capacitor & inductor in seriesparallel resonant has capacitor & inductor in parallel
The electric potential inside a parallel-plate capacitor is constant and uniform between the plates.
It is called a varactor or a varicap diode. Its capacitance varies nonlinearly with the reverse voltage applied to its terminals.
Simply include the diode in one of the AC supply lines to your capacitor. (not sure what a salt water capacitor is) but, all capacitors only store charge, which is discharged as a DC current.