answersLogoWhite

0

The input to the max232 ic will be of Transistor Transistor Logic (TTL) and its voltage range will be of 5 volt. The output of the max 232 ic will be of Recomended Standard 232 Logic (RS232 logic) and its voltage range will be of 12 volt. The max 232 ic which is operating on 5 volt supply has to step up the 5 volt input to 12 volt. Hence a capacitor is used for pumping the voltage and called as pumping capacitor.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How to connect 3 phase power factor correction capacitor?

how to connect power capacitor with 3 phase motor


What will happen if you connect 12volt battery to a 240VOLT capacitor?

If the capacitor is charged then the battery will explode.


How do you connect a targa capacitor to your amplifier?

To connect a Targa capacitor to your amplifier, first ensure the amplifier is turned off and disconnected from power. Connect the positive terminal of the capacitor to the positive power terminal of the amplifier, and the negative terminal of the capacitor to the negative power terminal. Finally, connect the capacitor's ground terminal to a solid ground point on the vehicle. Always double-check your connections and polarity before powering the system back on.


What is the function of a capacitor's leads?

To connect it to the circuit.


Can blackberry 8900 connect to tv?

No, you would need an alternating capacitor to connect.


How do you connect a capacitor in simulink?

To connect a capacitor in Simulink, you can use the "Capacitor" block found in the Simscape > Electrical > Specialized Power Systems > Elements library. Drag the block into your model and connect its terminals to the appropriate components, such as voltage sources or resistors, to complete the circuit. Ensure that you configure the capacitor's parameters, such as capacitance value, in the block's dialog box for accurate simulation results. Finally, connect necessary measurement blocks to analyze the capacitor's behavior in the circuit.


How to add a capacitor and resistor in parallel?

To add a capacitor and resistor in parallel, simply connect one terminal of the capacitor to one terminal of the resistor, and then connect the other terminal of the capacitor to the other terminal of the resistor. This creates a parallel circuit where both components share the same voltage.


Why connect capacitor to alternator?

To help produce voltage.


Can a non polarized capacitor be connected to a direct current circuit?

Yes, you can connect a polarized capacitor to a direct current. Make sure you get your polarization is correct.A non polarized capacitor can be connected in a DC circuit as well. "Non Polarized" just means it does not matter which side of the capacitor is positive. If you attempt to connect a polarized capacitor in a DC circuit backwards, you will know when the capacitor explodes.


Max232 interface with at89s52?

yes


In max232 what does max stands for?

maximum 232


How do you connect the capacitor bank in electrical system?

improvement of power factor