because its overloaded
Yes. A motor is considered to be a load of the power supply in use.
No load speed is the speed that the motor run when it has no load, i.e., the motor is separated from the engine, that speed is than greater than the rated speed, because the rated speed is the speed whwn the motor are linked to the load and it is the full load.
Full load starting current is typically in the region of 5or 6 times the full load motor current;.
If transformer then it refers to that, the primary is charged, but secondary is open, (no load is connected) If motor, it refers to that no load is connected to motor, the shaft is decoupled from the load, but running with out any load.
heavy load
the speed N is inversely proportional to armature current I. At light loads this current is very small. Hence motor will run at very high speed when started on no load/light load.........
Induction motor by design is inductive load. Hence the PF tends to be lower
To connect mechanical load to a motor, you couple it to the shaft of the motor.
It depends on whether the motor is run on load or whether it's running light.
Motor will rotate at very high speed leading to destructionAnswer from Kinindia.com
Yes. A motor is considered to be a load of the power supply in use.
No load speed is the speed that the motor run when it has no load, i.e., the motor is separated from the engine, that speed is than greater than the rated speed, because the rated speed is the speed whwn the motor are linked to the load and it is the full load.
It's a power outputThis answer is incorrect.A 'load' is the name given to any device supplied by the circuit. For example, a motor could be a load, or a resistor, a lamp, etc.
Full load starting current is typically in the region of 5or 6 times the full load motor current;.
dc motors can be operated at no load as well as at load condition.But by using the swin burns test the efficiency can be calculated at no load which is more benficial than load test.At industries this swin burns test is used because for load test we have to give separate supply for the load to run.In no load test that power is saved.
Generally a motor drives some equipment, it could be a fan, or a pump, connected to motor's shaft. The speed of the motor when no equipment is connected to its shaft is known as no load speed.
If transformer then it refers to that, the primary is charged, but secondary is open, (no load is connected) If motor, it refers to that no load is connected to motor, the shaft is decoupled from the load, but running with out any load.