* === === : === === : === === :
If, by 'one piece', you mean solid -as opposed to laminated- then the answer is that a solid core will have significantly-higher eddy current (circulating current) losses than a solid core.
to reduce the eddy current loss in the machine
Instead of a single piece of metal, the armature is made up of laminated thin metal plates. The thickness of the laminations is determined by the supply frequency. They are approximately 0.5mm thick. For the armature core, silicon steel laminates are used to reduce eddy currents and hysteresis losses.
When light enters your pupils, it refracts on your cornea and projects an image of your surroundings on your retina, a tiny screen in the back of your eye.
The alternating current flowing through transformer windings changes its polarity with each reversal of the current polarity, simultaneously changing the orientation of the induced magnetic poles within the core material. This constant fluctuation creates heat and other undesirable effects within the transformer, reducing its efficiency. Transformer cores are made of laminated steel or iron to minimize the effects of this electromagnetic phenomenon, which is known as hysteresis.AnswerThe alternating current flowing through a transformer's primary winding induces voltages into the transformer's core, as well as in the secondary winding. The voltages induced into the core create currents that circulate within the core -these are called 'eddy currents'. Laminating the core reduces the effective cross-sectional areas through which the eddy currents circulate, thus increasing the resistance to those currents, and reducing the associated losses (eddy-current losses). In addition to this, laminations allow the transformer core to be assembled much more easily than using solid cores.
The iron core of Transformers is laminated to reduce eddy currents, which cause a loss of energy.
by using the laminated core
choke
Insulation of laminated core is required to reduce the circulating current points due to touching the two plates. This results in more iron loss and heat produced
Hysteresis and eddy current loss constitute core loss. It can be reduced by replacing solid core by laminated core... by adeeb
Laminated steel plates.
The iron core of transformers is laminated to reduce eddy currents, which cause a loss of energy.
No, the purpose of laminating the core is to reduceeddy-current losses.
a laminated core and a shading coil
A core made of solid or laminated iron, or some other magnetic material which may contain very little iron.
Primary and secondary winding and mutual induction principle.
The laminations reduce a core loss called Eddy Currents, which are set up in the core by the ever changing AC current.