0
The impedance of a centre fed dipole at resonance is about 73 ohms. The feed impedance of a folded dipole is four times that, 292 ohms. The feedpoint is of course balanced in both cases, thus 300 ohm balanced line is an excellent match for the folded dipole active element of a commercial TV antenna.
What else can I help you with?
What is 16 awg wire rated for?
16 AWG wire is typically rated for a maximum current of about 3.7 to 10 amps, depending on the installation conditions and the type of insulation used. For power transmission in residential applications, it is often used for low-power devices and lighting circuits. The wire can handle a maximum voltage of around 300 volts in most cases. Always consult local electrical codes and regulations for specific applications and safety requirements.
What is wire classification CL3?
CL3 wire classification refers to a type of cable used for low-voltage communication and signaling applications, specifically in residential and commercial settings. It is designed to carry signals at a voltage of up to 300 volts and is often used for structured cabling systems, such as for alarm systems, intercoms, or data transmission. CL3-rated cables are typically less restrictive than higher classifications, allowing for installation in various locations, including within walls and ceilings.
How many amps is 250 MCM wire good for?
300 Amps if used for service entrance conductors. Table 310.15
How close can you put a fence next to an underground power line?
Underground power lines are supposed to be 36" deep. The power company will come and mark the location of the lines for free. You are responsible if you do not request the locate.
Why voltage is generated at lower value?
Are you are asking why an alternator's terminal voltage needs to be increased, using a transformer, for transmission? The answer is that the voltage supplied by an alternator is determined by how many conductors can be inserted into its stator slots and this, in turn, is limited by the physical size of the alternator. So the output of alternators is limited to around 300 kV.
Will a Chevy 350 bolt up to a ford 4 speed transmission that fits a 300 in-line 6?
NO it will not.
Where is your Chrysler 300 transmission stick?
The transmission dipstick on a Chrysler 300 is a special tool that only the dealer has.
How do you check transmission fluid in a 2007 Chrysler 300?
How do you check transmission fluid on a 2007 chrysler 300 touring
How do you Check transmission fluid in a 2003 Lexus Gs 300?
How do I NEED Check transmission fluid in a 2003 Lexus Gs 300?"
How do i check transmission fluid in a 1990 Chrysler 300?
There wasn't a 1990 Chrysler 300.
Do you have to drain all the fluid out the engine before you put in a new transmission in a 1989 Nissan 300 ZX?
No, not from the engine. You only have to drain the trany. fluids.
Will a Chevy 350 bolt up to a ford 4 speed transmission that fits a 300 in line 6?
You would need to purchase the correct bellhousing, then it should work out fine.
Where do you add transmission fluid to a 2.7 Chrysler 300 touring?
You add transmission fluid to a 2.7 Chrysler 300 Touring at the dipstick tube behind the engine.
What kind of transmission does the 2010 Chrysler 300 have?
The 2010 Chrysler 300 has a 4-speed automatic.
What kind of transmission does the 2008 Chrysler 300 have?
The 2008 Chrysler 300 has a 4-speed automatic.
What kind of transmission does the 2009 Chrysler 300 have?
The 2009 Chrysler 300 has a 4-speed automatic.
What kind of transmission does the 2006 Chrysler 300 have?
The 2006 Chrysler 300 has a 4-speed automatic.
