answersLogoWhite

0

No, there is over a 15% difference in voltage supplies. This means that the current supplied to the 208 volt equipment will also be 15% higher. Take a 4000 watt range. I = W/E 4000/240 = 16.6 amps. 4000/208 = 19.2 amps. A 240 volt appliance will run on 208 volts but as you can see from above equation the range elements will not get as hot at the lower voltage.

<><><>

To get a the answer you have to reckon with the resistance of the appliance. A 4000 watt appliance running on 208 volts takes 19.2 amps, so from Ohm's Law R = E/I, its resistance must be 208/19.2 = 10.83 ohms.

Again using Ohm's Law I = E/R, the current that resistance takes at 240 volts must be 240/10.83 = 22.16 amps. So the power drawn will be 22.16 x 240 = 5,318 watts.

If it is a cooking ring or a heater, that power may cause the temperature to rise so much that its element could glow dangerously white hot and, at best, it may then melt or burn away with lots of smoke and heat. If it was some other appliance it may well overheat so much that it simply catches on fire. So the real risk here is that, if left unattended, the higher voltage could cause a house fire.

<><><>

As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.

Before you do any work yourself,

on electrical circuits, equipment or appliances,

always use a test meter to ensure the circuit is, in fact, de-energized.

IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB

SAFELY AND COMPETENTLY

REFER THIS WORK TO QUALIFIED PROFESSIONALS.

User Avatar

Wiki User

15y ago

What else can I help you with?

Continue Learning about Electrical Engineering

How do you use 120V equipment on 240V?

The short answer is: you can't. The long answer is: just like using a flashlight bulb that has a voltage that is half the voltage of the battery, it will not work. It will take too much current, causing it to burn out and be useless.


Can you wire a 347 volt ballast to a 120 volt fixture?

Yes, but it will not work.


Will a switching power supply work on 277 volts?

Not unless it is rated for that voltage. You can likely find a step down transformer from 277 volt sto 120 volts.


Why arent homes wired in series?

If a home were wired in series, every light and appliance would have to be turned on in order for any light or appliance to work.Because people dont like it


Can you use 600 volt fuses in place of 250 volt fuses on a 208 Volt System?

Answer for USA, Canada and countries running a 60 Hz supply service.If they fit, which I doubt, yes, you can use 600 volt fuses in place of 250 volt fuses so long as the amp rating is correct.YOU CANNOT USE 250 VOLT FUSES IN PLACE OF 600 VOLT FUSES !!!You can use a fuse with a higher volt rating but not a smaller volt rating than the voltage applied to the circuit.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.

Related Questions

Can a 220 Volt 50 Hz appliance work on 240 Volt 50 Hz?

Yes, a 220 Volt 50 Hz appliance should work on a 240 Volt 50 Hz supply. The appliance would receive slightly more voltage, but typically a small variation like this should be within the appliance's acceptable range. Just ensure that the appliance is rated for the higher voltage to prevent any potential damage.


250 volt appliance work in 220 volt world zone?

normally, appliance are built in 110v or 220v, applied in 100-140v and 200-240v. if your 250v appliance is common home appliance equipment, then 220volt is ok, i think. otherwise, you should ask the vendor for special power supply.


Does an 180 volt appliance require 240 volt supply?

No, it requires a 180 Volt supply. Most appliances work +/- 10%, in this case 162 Volts to 198 Volts. I would question whether your appliance is really 180 Volt. No country uses this as domestic supply, it is usually 110V or 220-240V.


Will 200 volt appliance work in with 240 volt supply?

It will work but not as efficient as the manufacturer designed it to. If motors are involved in the appliance they will run hotter as they will draw a higher amperage due to the lower voltage. Appliances with a wattage rating for heating elements will not reach their nameplate wattage rating.


Can you change wall plugs 110 volt systems to suit 240 volt appliances?

No, you cannot simply change the wall plug to make a 110 volt outlet support a 240 volt appliance. The voltage requirements of the appliance and the outlet must match for safe operation. You would need to install a dedicated 240 volt outlet and ensure that the wiring and circuitry can handle the higher voltage. It is recommended to consult a licensed electrician for this type of electrical work.


Can a home appliance work on 230 volt AC which is designed for 120 volt AC?

No, the voltages are too far apart. Some equipment can work on both voltages but they have a switch on the back of the equipment to change from one voltage to the other.


Can 115 volt appliance be plugged into Canadian household outlet?

Yes. All Canadian regular household outlets work at 110-120 Volts.


Would 230 volt item applicance work on 220 volt in south Africa?

Yes, a 230-volt appliance should work fine on a 220-volt outlet in South Africa. The small difference in voltage is usually within the tolerance range of most appliances. However, it's always a good idea to check the appliance specifications to ensure compatibility and avoid any potential damage.


Can you use a 240 volt electrical appliance Bose ipod speaker bought in Indonesia in the US on the 110 volt what do we need to get the speaker to work in a US home?

Yes this can be done. You need to look on line for a travel converter.


Can you use 220 V with 60 Hz appliances from South Korea in US with 240 V outlets?

If the appliance is 220 volt 60 Htz, yes it will work perfectly in the U.S. plugged into a 240 volt outlet.


Can you use 230 volt appliance in a 240 volt plug socket?

Yes, you can typically use a 230V appliance in a 240V plug socket without any issues. The slight voltage difference is unlikely to cause damage to the appliance. However, if the appliance is sensitive, it's always best to refer to the manufacturer's guidelines or use a voltage converter for added safety.


Can a 120 hair dryer work with a 110 outlet?

Yes - a hair-dryer rated at 120 volts will work in a 110 volt outlet.