I do not believe any lighting fixtures of any voltage have ever been made to work off of three-phase circuits. Light Fixtures are always single-phase 2-wire circuits In the USA the standard voltages for branch circuits are: 120, 208, 240, 277 or 480 The light fixture must be rated to match whichever field voltage is being used. Some light fixtures are made multi-rated so they can be used on more than one circuit voltage
Question is incorrect. in a 240 Volt single phase circuit, how can you have A phase and B phase?
No you need a Roto Phase
Yes it would work pretty well but it might not meet its accuracy specification.
NO! The voltages available in the 3-phase system are 480 (if you wire phase to phase) and 277 (if you wire phase to neutral) Don't try it!
120 volt single phase rectifies to about 96 volt DC
no
Question is incorrect. in a 240 Volt single phase circuit, how can you have A phase and B phase?
No you need a Roto Phase
Yes it would work pretty well but it might not meet its accuracy specification.
NO! The voltages available in the 3-phase system are 480 (if you wire phase to phase) and 277 (if you wire phase to neutral) Don't try it!
120 volt single phase rectifies to about 96 volt DC
220 volt single phase from 480 volt 3 phase that one wire taken one phase and second wire connected in earth point. we get 220 v The above answer is incorrect, one phase from a three phase 480 volt system will give you 277 volts to ground. You must use a transformer to get the voltage you need.
You can not change it. 440 volt is by design. However you run it with 220 single phase supply, but it would run far lower power.
A single phase 600 to 240 Volt transformer using two phases of the three phase primary.
Yes, if the motor is rated 240 volts 3 phase.There is such a thing as 240 volt 3 phase power.However if you are asking if you can use 240 volts single phase on a three phase motor, then the answer is no.
You Don't. 440volt 3-phase is actually 480 volts, taking a single phase gives 277Volts single phase. To get single phase 440 you would use one leg of three phase 440/760 three phase power.
All my experience with rotary phase converters have been in converting 240 volt single phase into 240 volt three phase. They all were hard wired into their respective systems, so my answer is no.