Yes it can run when single phasing in a delta configuration but the motor will not start from a dead stop. There will be quite a bit of degradation in its operation from its nameplate data.
In a single phase 220 volt electric motor just measure one line. That already represents your line current. That line current is equal to your total current circulating in your motor.
If the motor wire numbers are L1, L2 and L3, it is not a single phase motor. It is a three phase motor. Also for future reference, a 220 volt single phase motor does not use a neutral.
If a 48 Volt club car electric motor requires 48 volts, then it should be given a 48 volt power source, or something close to it. Too many more volts and it may burn out; not enough volts and it may not run or it will try to draw too much power and burn out the power supply.
P = iv
That's a powerful motor, and would need a supply greater than 13 amps at 240 volts, also the conversion might be difficult. I have a feeling that you would be better off finding out how powerful a motor you would need for the task you have, then buying a suitable 240 volt motor. You are heading into territory where you should really consult a qualified electrician.
Yes.
It is not advisable to run lower voltage motor on a higher voltage.
....on an automobile it is a 12 volt DC motor. the electric cooling fan is driven from this type motor.....
The Chevy Volt uses gas to power an electric motor.
Yes but it has to be processed first. Programmable controller has the ability to take a 4-20 signal as an input and after processing close an output which can close a motor contactor.
In a single phase 220 volt electric motor just measure one line. That already represents your line current. That line current is equal to your total current circulating in your motor.
If the motor wire numbers are L1, L2 and L3, it is not a single phase motor. It is a three phase motor. Also for future reference, a 220 volt single phase motor does not use a neutral.
Go to the website of a motor starter manufacture, such as 'Square D'.
Depends on the electric motor, most models use the Mabuchi 540s which is rated from 6 volt - 8.4 volt. If that's fitted you should be OK!
If a 48 Volt club car electric motor requires 48 volts, then it should be given a 48 volt power source, or something close to it. Too many more volts and it may burn out; not enough volts and it may not run or it will try to draw too much power and burn out the power supply.
P = iv
You can but the motor may not run, however you will not burn the motor.