Yes they can.
The same that is used above ground. Sweat fitting coupler. I would not use copper underground in an area that has winter.
A street fitting is a fitting that is designed to attach to another fitting, It can also be one that is design to connect two or more fittings together. It can be destinguished by its male end or ends that will fitt snuggly into the female end of another fitting of the same diameter. They or sometimes used to simplify a connection, to make a connection in a tight or unusual spot, and to change direction. A street fitting can be an ell (elbow), a tee, an adapter, etc.
In underground areas. In underground areas.
A tube connector is the standard fitting that goes on a tube or hose. A tube adapter fits to a tube or hose and enables it to connect to a fitting of a different size to its standard.
Poetic Justice
Victaulic makes a dielectric fitting that could solve your issue.
A Victaulic fitting is really a grooved end fitting that is used with grooved end pipe, joined with a coupling. These are found on a variety of commercial and industrial piping systems. Victaulic is the company that originated the grooved piping method so the name "Victaulic" is their registered trade name. The correct generic terminology for these fittings is simply grooved end fittings.
Victaulic products have a long history of being used on underground piping systems.
The take-off measurement for an 8-inch Victaulic 45-degree fitting is typically around 7 inches. This measurement is used to determine the distance from the centerline of the fitting to the point where the pipe will be cut or connected. However, it's essential to consult the manufacturer's specifications or installation guidelines for precise dimensions, as they can vary slightly.
Victaulic was created in 1925.
The take-off for a 4-inch long radius Victaulic 90-degree fitting is typically around 4.5 inches. This measurement refers to the distance from the centerline of the pipe to the end of the fitting. It's essential to refer to specific manufacturer specifications for precise dimensions, as they may vary slightly.
Yes , it is required, any water base lubricant on the gasket inside the fitting is required before final connection.
1-13/16"= The tangent of half the degree X the radius of the elbow.
Takeoff measurement for a 4-inch Victaulic 90-degree elbow typically refers to the distance from the centerline of the pipe to the end of the fitting. For a standard 4-inch Victaulic elbow, this measurement is generally around 4 inches, but it can vary slightly based on the specific manufacturer and design. Always consult the manufacturer's specifications or installation guidelines for precise measurements.
The take-off measurement for a 4-inch Victaulic 45-degree fitting is typically around 4 inches. This measurement refers to the distance from the centerline of the fitting to the centerline of the outlet. However, it's always best to consult the manufacturer's specifications or technical data sheets for the most accurate details, as dimensions can vary slightly based on the specific design and application.
no
250