answersLogoWhite

0

What else can I help you with?

Related Questions

What contraception can be used to block the entrance to the uterus by fitting directly over the cervix?

The cervical cap


What holes do you block when fitting 4g63t head on a 4g64 block?

When fitting a 4G63T head onto a 4G64 block, you need to block the coolant passages that are not aligned between the two components. Specifically, you'll typically need to block the two coolant holes at the rear of the head that do not match up with the block. Additionally, you should ensure to use the appropriate gasket to prevent any leaks and ensure proper sealing. It's also important to verify that the oil passage alignment is correct to avoid engine damage.


What is a termination block?

it is the block which is used to splitting the two circuit


What does CXC mean in plumbing terms?

When it comes to a plumbing fitting, description CxC means the fitting is Copper by Copper, or the fitting is used to join two pieces of copper


What is a terminal connector block?

it is the block which is used to splitting the two circuit


Is fitting room one word or two?

'Fitting room' is two words.


On a 87 Chevy 350 can block fitting between rear 2 cylinders on passenger side be used for temperature sending unit?

You must mean the head not the block. Yes it can but use teflon tape.


How do you find the thermostat on 1991 Acura RS?

How to change thermostat: Drain coolant by removing drain plug on radiator. Locate lower radiator hose and follow it to engine block. Pull the hose from engine block to expose the fitting/thermostat cover. This fitting is held on with two 10mm bolts. Remove to expose thermostat.


What is the difference between detoit 8v71 cylinder liners 3 and 2?

The difference is the outside diameter, it is used for fitting the liner in the block as they are dry liners.


What is terminal blocks?

it is the block which is used to splitting the two circuit


State the two situations in field where differential pully block is used?

The differential pulley block is used in the United States Naval Education.


Why is it called Hub and spigot drain pipe?

The Hub and Spigot are two types of fitting on either end of a pipe.At one end you have the Hub (Socket) fitting; which is a "female" end of a fitting designed to accept pipe or a SPIGOT connector.At the other end you have the Spigot fitting; which is a "male" end of a fitting designed to be used inside another fittings Socket (or Hub) end.