1. Replace the pipe, 2. Shut off the water
Rub it with some Goof Off on a rough rag for 2-3 minutes. By then it's soft enough to slide a craft knife under an edge and peel it off.
When you say 1/2" are you talking about 5/8 OD or nominal size and which type of copper? K /L/ M as there is friction looses to consider I am referring to 1/2" nominal type L copper pipe, and the friction loss is negligent because the section of 1/2 inch tubing is only 2" nipples on either side of a electric shut off valve. The actual set-up is 1" PVC supply at 65psi, reduction fitting to 3/4" into a pressure redusing valve, 3/4" out of the valve through another reduction fitting to 1/2" into and through the shut-off valve, then into the furnace. Distance from the first 1' to 3/4" reducer to the furnace is only a distance of about 14". Hope this helps.
Clearly it means, "No more profits or monies to be gained by the Oil or Gas well", or B.P. would have shut the oil well down instead of letting it leak almost 2 Million Gallons of Oil to Leak into the Ocean.
The detailed directions are printed on front of EVERY gas regulator. - However, in general terms, turn regulator switch to OFF for 2 minutes, then to PILOT and depress for one minute, then light pilot or press clicker till it lights. Keep PILOT pressed for 2 more minutes then slowly release it. If it stays on then turn main switch to RUN or ON. -If you have to light the pilot manually, use a barbecue match (12 inches long)
I want to extend the automatic shut off from 30 seconds to 2 or 3 minutes so i can get into the house,,,thank you
hold the power button, then hold the shut off button at the same time. then let go. wait for 2 minutes. then shut off your computer.. then turn it back on. then it will be reseted.
censor in the side sliding door needs 2 be changed or the other doors,try narrowing it down to one of thes doors i did.
Check your electronic module.
Dodge does not use inertia/shut off switches.Dodge does not use inertia/shut off switches.
Start with 3 1/2 and then run the engine for 2 minutes and then shut off and check dip stick in 10 minutes. A liter is slightly larger than a U.S. quart.
no there is no fuel shut off. This is correct, there is no fuel shut off switch on that early of a model, or any s10 for that matter.
Start with 4.5 quarts, after draining oil and replacing filter. Start engine and run for 2 minutes. Shut off and wait 30 minutes. Check level and add if needed. You now know.
Any of the following can cause it to shut off......... 1. Turn off the switch.. 2. Turn off the ignition key.. 3. Change the control to heat only..
Drain the oil, remove and replace the filter. Add 4.5 quarts. Start the engine and let it run for 2 minutes. Shut it off, wait 15 minutes. Check the level and top it off. You now know.
2 months
If they reach their full charge in 2 hours then the charger is suppose to shut off.