0
What else can I help you with?
Output power rating of PWSA card in Ultra BTS?
600 WATT
Why be use the -48 volt for bts?
48 is volt scale and negative voltage is used for safety of media, to prevent attanuation and noise.
What is TRX in bts?
TRX stands for TRANSMIT RECEIVER. TRX has different combination depending on the user requirement. 1 trx has 8 TS out of which one is allocated for BCCH.Rest is used for voice trxmns and for data purpose.
Why negative voltage is used in BTS in GSM system?
Because 2 terminal comes out from the battery and through red wire we ground the +ive terminal so that possibility of noise interference will get zero....noise occur only in the +ive terminal.....thats why we use -ive voltage.
How to commissioning ultra and flexy bts?
this would need some more detail , to be specific , and dependant on whether temperature, pressure , level or flow types. .. generally you should consider the impact if the system fails / would it result in a catastrophic situation arising, resulting a dangerous condition .? are there any fail safe emergency arrangements needed to continue cooling via pumps, or safety valves to control a pressure safely. is the new system about to be commissioned the right type for the application ? .. is installation - method the correct one.? are the sample and return pipelines set up correctly ? are there any intrinsic - safety requirements? should a valve stem or piece move during its operation ; will it clear any local objects or strike them resulting in a failure ? . is the electrical system designed suitably for the power consumption ? are there any IP - protection sealing requirements needed ? . if the application involves a flow measuring system ; the isolation -- valves should be commissioned by equalising the pressures across the instrument manifold. then opening slowly theLP low pressure isolator, and then fully, and finally opening the HP isolator to commission the instrument .
What is the full form of bts?
Answer'BT'British Telecom (Corporation)Bit Torrent (form of Peer-to-Peer file Sharing)Brian Wayne Transeau (Musician)Bacillus Thuringiensis (natural insecticide)Perhaps if you were a bit clearer on what it is you're asking about,the answer could be more clearly defined. Thank you.
Full form of BTS?
Bangkok Mass Transit System (BTS)
Sir please full load in ultra bts?
full load on one bts site 35 amp.
Why is soft and hard handover use?
If Your Question is related to Telecom Wireless, this is the Ans: Handover is used to continue the service being used, if a user moves from serving BTS to Target BTS.
What is the function of fxc rri card in nokia bts?
The function of FXC Card, is to provide E1 conectivity to BTS. It have four E1 port and it can be used to connect other bts as "cascade". Where do you hear about this card? Do you work for a telecom company? Please, let me know in order to help you.
What the full meaning of bts?
Well, there are lots of meanings for bts. here are some exmpels...: -Burn the stage -behind the senene and more!! Bts is a bangtan k-Pop artist a that is takeing over the world!!
Why use power interface unit in telecom?
it is a unit in a BTS i.e. base transreciever system..these bts are installed with towers that are used for mobile communication. The piu consists of a power plant and battery bank. power plant has rectifier to convert ac to dc and battery back up is used in case of power failure.
What is h difference between 2g bts and 3g bts?
3g BTS is greater than 2g bts. and it is with new technologies.
Difference between indoor bts and outdoor bts?
Indoor BTS: It is placed in a shelter Air-condition is must Very sensitive Outdoor BTS: No shelter required Air-condition is not a must Not very sensitive comparing to indoor bts
What is the power range of BTS?
GSM900 transmitted power from BTS: 39dBm GSM1800 transmitted power from BTS: 36dBm
When was BTS Group created?
BTS Group was created in 1986.
What is BTS in telecom?
(B)usiness (T)elephone (S)ystems Generall a part of a telco providers, or a stand alone venodr that sells the phone systems and othe ancillary equipment to go with it. Mitel, for example would be BTS Equipment, so would NEC Equipment.. Both are sold by a number of different retailers across the world. In Telecommunication, BTS stands for Base Transceiver Station. They are used as communication nodes in a mobile network and are placed at different location within some defined area where the Network Operator is licensed to operate. BTS are station, usually a room wherein a Rack for Transmitter, Receiver, Power Control device, Analog to Digital equipments, AC for lowering temperature within a room are placed and on the top of the house is placed sectored or omnidirectional antenna. They are communication nodes of a mobile network that relays data from mobile to BSC, which then sends it to the MSC. For BTS rack see the Related Link.
