Electrical
Electrical current is measured with an ammeter and in units called amperes, or amps.
Stream Flow
River flow or current (discharge) is measured in cubic feet per second or cubic meters per second.
Electrical current is measured in amperes.
V = IR Voltage (V, measured in volts) = Current (I measured in amps) times Resistance (R, measured in Ohms) Is your current 3.13? I'm not sure what you wrote there, but just multiply your current times your resistance.
the capacity of a transformer is defined as a product of voltage and current flowing through it.AS THE CURRENT IS MEASURED IN AMPERES AND VOLTAGE IN VOLTS, Hence transformers are measured/rated in KVA
No one is going to be able to tell you that. You are looking for the measured voltage, so go and measure it. In any case, if you were just looking for the voltage it will depend on the circuit current. You can work it out using ohms law (Voltage = Current * Resistance).
Voltage can be measured using the difference between the potentiel between two ends of wire or by using a volt-meter. You can easily measure volt by volt or multimeter but remember voltage always measure across the components but in parallel
If there is no current, there is no power.The voltage can be measured with a voltmeter.
Electrical current is measured in amperes.
Because of the polarity of the circuit. The signs of measured current and voltage depends on the direction of the current and voltage.
The three electrical quantities are current voltage and resistance. Current is measured in amperes (A) and is the rate at which electricity flows through a conductor. Voltage is measured in volts (V) and is the electrical force pushing the current through the conductor. Resistance is measured in ohms () and is the opposition to the flow of current. Current - measured in amperes (A) Voltage - measured in volts (V) Resistance - measured in ohms ()
Electric current is measured in amps not voltsElectric voltage is measured in volts.
Alternating Current is measured in Amperes.
The current is the amperage. It is measured in series. Voltage is measured across the line (parallel).
The voltage across a load in a circuit with alternating current is typically measured using a voltmeter. The voltmeter is connected in parallel to the load, allowing it to measure the effective voltage or RMS voltage across the load. This value represents the average voltage of the alternating current waveform.
voltage is measured in terms of volts ; current is measured in terms of amps.........................................
V = IR Voltage (V, measured in volts) = Current (I measured in amps) times Resistance (R, measured in Ohms) Is your current 3.13? I'm not sure what you wrote there, but just multiply your current times your resistance.
the capacity of a transformer is defined as a product of voltage and current flowing through it.AS THE CURRENT IS MEASURED IN AMPERES AND VOLTAGE IN VOLTS, Hence transformers are measured/rated in KVA
Voltage is what is measured in volts. This is the electric potential difference between two places. The electric current is also measured so as to ascertain the voltage.