Current flow would be the same through the resistor, since it's in series, but the voltage would be slightly reduced based on the resistance.
If you have 2 resistors in parallel, the current will divide through each resistor, and the voltage stays the same.
PLL
Ohm's law and water flow - PLL
A resistor.
An inductor will supply better current source.
A series dropping resistor is a resistor that limits the amount of current flow in a circuit.
IF there is a Resistor
half of the current flowing thru resistor 1.... V=IR.
When an electric current flows through a resistor, the resistor resists the flow of the current, causing a decrease in the current. This decrease in current is proportional to the resistance of the resistor, as described by Ohm's Law.
Current flows through a resistor, not across it.
It is done in order to protect the transistor from the heavy currents flowing (resistor reduces current flow) into its terminals.
It depends on the purpose for installing the resistor. If the intent is to decrease current flow, the resistor must be connected in series with the load. If the purpose is to increase current flow, the resistor must be connected in parallel with the load. To connect a resistor in series, connect the resistor to one side of the power source, in line with the load. This will decrease circuit current flow. To connect a resistor in parallel, connect the resistor between the positive and negative sides of the power source, which will effectively connect the resistor across the load . This will increase current flow through the circuit. However, before connecting a component in parallel, make sure the increase in current flow will not exceed the current rating of the circuit or fuses/breakers will blow.
A resistor.
A resistor affects the flow of electricity in a circuit by reducing the current that flows through it. This reduction in current leads to a decrease in voltage across the resistor.
Current flows in loops, voltage drops across elements. With relation to current, what flows in, must flow out, so no, current is not dropped across a resistor, it flows through a resistor and voltage is dropped across the resistor.
A ballast resistor is an electrical resistor whose resistance varies with the current passing through it, thus maintaining a constant current.
resistor is to resists the flow of current
An inductor will supply better current source.
The correct question is what is the voltage drop across a resistor or the current flowing through the resistor using Ohm's Law where Voltage = Current x Resistance
A resistor reduces the flow of current in an electrical circuit, which in turn affects the voltage across the resistor.