Yes
To connect PVC pipe to PEX, you'll need a few specific fittings. Start by using a PVC to PEX adapter, which usually has a female threaded end for the PVC and a barbed end for the PEX. First, glue the PVC adapter onto the PVC pipe using PVC cement, then slide a PEX clamp ring over the PEX pipe, insert the PEX into the barbed end of the adapter, and secure it with a crimp or clamp fitting. Make sure to follow all manufacturer instructions for a secure and leak-free connection.
Yes.
Galvanized Iron pipe
galvanized iron pipes commonly used on water pipe lines, it is dipped into zinc for corrosion protection
It's a type of pipe
May be a PBC Pipe, is my good guess....
A threaded copper fitting on the copper side, male or female, and the galvanized is screwed into it.
At what temp does pex pipe freeze
You need each piece to have a threaded end fitting, one male, one female.
To connect PEX pipe effectively and securely, you can use a PEX crimp ring or a PEX clamp ring along with a PEX crimping tool. First, slide the ring over the end of the PEX pipe, then insert the fitting into the pipe. Use the crimping tool to compress the ring tightly around the fitting. This creates a secure and leak-proof connection.
To learn how to connect PEX pipes properly, you can follow these steps: Cut the PEX pipe to the desired length using a PEX pipe cutter. Insert a PEX fitting into the end of the pipe. Use a crimping tool to secure the fitting onto the pipe. Repeat the process for the other end of the pipe. Test the connection for leaks by running water through the pipes.
No. Galvanized pipe is what they used to use, and now should either be replaced with modern type of water pipe such as PEX or copper. COMMENT: Complete agreement. Galvanized served it's purpose and did bring water into a lot of people's homes for a lot of years. That was then, this is now. Today, it would be a dead last choice for a plumbing system.
GI Pipe is "Galvanized Iron" Pipe. These days the pipe will likely be made from steel rather than iron.
Yes, PEX pipe can be buried underground as it is commonly used for underground water supply lines.
The copper should fit in the Pex fitting. My mistake, Pex uses the crimp rings. There is a coupling and other fitting that you just push the pipe into and it grabs and seal the pipe. Pex, pvc, copper, all will fit. Just use a coupling between the copper and the pex. I had my doubts the first time I used this, but it does work and doesn't leak. Just make sure that the pipe bottoms out in the connection.
Pvc, Wirsbo, Copper, galvenized, pex, or Polyethylene
For cold water,start at the water meter, the follow it to the hot water tank for the hot lines. They are pretty easy to see, they are either copper or pex, or galvanized pipe.